A 220-V long-shunt compound d.c. generator is supplying 100 A to a load. The resistances of the shunt field, the series field, and the armature are 50 ohms, 0.025 ohm, and 0.05 ohm respectively. Find the following:

A 220-V long-shunt compound d.c. generator is supplying 100 A to a load. The resistances of the shunt field, the series field, and the armature are 50 ohms, 0.025 ohm, and 0.05 ohm respectively. Find the following:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: what is then the induced e.m.f.

Q: 1. A series generator supplies to a load of 100A. Armature and field resistances are 0.055930 and…

A: Given: Current, I=100A, Armature resistance, Ra=0.05593 Ω, Field resistance, Rs=0.02593 Ω, Induced…

Q: Basics, Construction & Oper... A DC generator has armature emf of 200 V when it works on full…

A: Given- A DC generator- Armature emf = 200 V, Full flux/pole=40 mWb, Speed=500 rpm, Generated emf…

Q: 4. The de shunt generator is connected to a load that draws 28,800 watts, given the armature and…

A: In the question 4, we need to calculate the generated emf. We know output power Po= VI Where V…

Q: uèstion 7 A shunt generator running at 1000 r.p.m. has generated e.m.f. as 300 V. If the speed…

A: In this question, choose the correct option What is emf at speed = 1200rpm

Q: In a DC machine, the air gap flux density is 4 Wb/m2. The area of the pole face is 2 cm x 4 cm. Find…

Q: A DC generator has armature emf of 200 V when it works on full flux/pole 40 mWb, and speed of 500…

A: Given: For the 1st DC generator, EMF, E1=200 V Flux, φ1=40 mWb. Speed, N1=500 rpm. For the 2nd DC…

Q: 1. In a transformer, which options are correct: A. Works on Faraday’ law and Ampere’s law B. DC…

Q: 1.Two identical shunt generators running in parallel, each with armature resistance of 0.02 ohms and…

Q: An induction machine is supplied with phase input voltage of 22020 and input current 164-10. The per…

A: There are two types of machines depending upon the type of input. 1) AC machine- Induction…

Q: The DC shunt generator with the terminal voltage 350 V, armature drop 9 V and the each brush drop 4…

A: We need to tell about generated voltage for generator.

Q: A dc short shunt compound generator delivers 20 kW to a load at 500 V. The armature, series field…

A: In this question we need to find a power developed in armature .

Q: A DO shunt generator delivers 45 A at a terminal voltage of 220 V. The armature and the shunt field…

A: Given values are - IL=45AVt=220VRa=0.01ohmRsh=44ohmStray losses=375W

Q: If we need to use a DC generator witha very good voltage regulation we choose: * DC Generators…

Q: The terminal voltage of a 150kW series generator is 600V at rated load. Determine the efficiency if…

Q: Answer the inquiries of one of the trainees regarding the generators and transformers and their…

A: A. The direction of the induced emf in the figure 3 is B. The polarity of the given magnet system…

Q: The output of a shunt generator is 66A at 100V. Armature resistance is 0.04Ω and the field…

Q: a) What would be the speed of the armature, if flux per pole is 0.007 Wb? b) If the armature is…

A: Given, Number of poles (p) =6 Number of slots=50 Each slot contains 20 conductors. Hence total…

Q: 1. Variable loss in a dc series generator = la2 Ra. 2. Lap winding is suitable for high current,…

A: Will consider each statement separately.

Q: A. Draw the extemal characteristics curves series de generators.

A: Please find the attachment below

Q: A lap connected 6 pole DC generator has an armature conductors of 500 and is driven at 600 rpm. If…

A: The solution for the given DC generator is solved below and attached.

Q: PZ 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is…

Q: 4 Pole generator has a wave wound armature with 32 conductor per slot. The flux per pole is 40mWb…

Q: The field circuit of a 125-volt dc generator has a resistance of 50 ohms and an inductance of 12.3…

A: The solution is given below

Q: The frequency of voltage generated in SG depends on: Select one: a. Number of poles b. number of…

A: The synchronous speed of SG is So the frequency of voltage generated in SG depends on number of…

Q: An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each…

A: The information provided in question are:

Q: A long shunt compound generator supplies 29 A at 420 V. If the field resistance is 246 Q, the series…

Q: A 6-pole, wave-connected armature has 831 conductors and is driven at 612 RPM. If the flux per pole…

A: We know direct formula for generated emf

Q: A 4 pole generator with wave wound armature has 55 slots each having 25 conductors. The flux per…

A: From the DC generator

Q: A long shunt compound generator supplies a load consists of 172 shunt lamps each rated at 48 W, 235…

A: Long shunt compound generator Shunt field winding connected to the after series field winding.…

Q: The number of parallel paths and the number of series conductors required for a given kW rating of…

A: In this question , we will write about the number of parallel paths in dc machine depends hoon which…

Q: A short shunt compound generator supplies a load of 20 kW at 500 V. The armature, series and shunt…

A: Load current = power delivered to load/ terminal voltage voltage. Power developed = armature…

Q: Question: A 4 Pole DC Generator Is Wounded Lap. It Rotates At 50Orpm To Be Able... A 4 pole DC…

Q: Figure 1 shows an electric generator with 3 rotor windings as marked by a-1, b-2 and c-3. A…

A: The objective of the question is to design a 3-phase 3-wire connection for an electric generator…

Question

2. A 220-V long-shunt compound d.c. generator is supplying 100 A to a load. The resistances of the shunt field, the series field, and the armature are 50 ohms, 0.025 ohm, and 0.05 ohm respectively. Find the following:

2. c) The voltage drop across the series field
O 3.33 V
O 2.61 V
O 5.22 V
O 4.42 V
2. c) The voltage drop across the armature
O 4.42 V
O 5.22 V
O 2.61 V
O 3.33 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is 60 Amper on full load. The armature m.m.f is equal a) 5415 A.T b) 1353.75 A.T c) 2707.5 A.T d) 676.675 A.T
Kindly solve what is ask with complete solution so that I can understand. I want a handwritten solution. Thank you very much pots!
A single phase 60 Hz transformer has its core volume of 1.5x10-3 cu m. The maximum flux density is 1.0 tesla and the hysteresis constant of the core is 6000. find the hysteresis loss.
Armature windings in ac generators are same as those used in DC machines Select one: O True O False
q. 8
2. A 220-V long-shunt compound d.c. generator is supplying 100 A to a load. The resistances of the shunt field, the series field, and the armature are 50 ohms, 0.025 ohm, and 0.05 ohm respectively. Find the following:
Describe the figures below and how each of figure below are working
The field system is the rotating part of the DC Generator Select one: True False
Suppose there is a load that needs 120W of power and is located 50ft from a generator with a total resistance of 0.2525 Ohms. The load can be designed to operate at 12V or 120V. Find the voltage drop and power losses in the connecting wire for each voltage and comment on the results.
Example : In a 110 V, d.c. compound generator, the resistance of the armature, shunt field and series field are 0.06 , 25 and 0.04 respectively. The load consists of 200 lamps each rated at 55 W, 110 V. Find the total e.m.f. generated and the armature current when the machine is connected in (a) long shun
A self-excited shunt generator supplies a load of 12.5kW at 125 V, the field resistance is 25 ohms and the armature resistance is 0.1 ohms. The total voltage drop because of brush contact and armature reaction at this load is 3.5 V calculate the power generated.
A DC machine has total armature ampere conductors of 4500 and total flux in the machine is 0.14 wb. The torque developed in the machine is (in N-m/rad)