A 2-port network has the following scattering matrix: 0.467L- 144.01° [S] = 0.884 – 142.53° 0.884L – 142.53° 0.467438.95° Determine whether the network is reciprocal, matched and lossless.

Q: 3.16 An SSB-AM signal is generated by modulating a 600 kHz carrier by the signal m(t) = sin 3000nt +…

A: 1.

Q: Consider a BPSK system that has the sinc squared pulse shape, p(t) with amplitude 2 and the carrier…

A: Considering a BPSK  system that has the sinc squared pulse shape, p(t) with amplitude 2 and the…

Q: What is the power in one of the sideband of an AM signal whose carrier power is 350W with 80%…

A: In this question We need to determine the power of one sideband?  Power of one  sideband = u2 Pc/4

Q: 1)the average value of the signal is? /2) the effective value of the signal is?

A:

Q: 7.32. Data has to be transmitted from a remote space probe via an RF link. The baseband data signal…

A: Modulation is a process in communications where a characteristic of a carrier signal is varied in…

Q: The scattering parameters of a certain two-port network is measured to be 0.3 0.6 using 50 ohms…

A: According to the question, for the given S-matrix as shown belowThe characteristic impedance of the…

Q: Calculate the frequency difference between the original signal and the recovered signal

A: Given: To generate an SSB Signal, sinusoidal signals are being used with, Carrier frequency, fc=3…

Q: Consider a step index multimode fiber with a core diameter of (9.0000x10^1) (µm), a core refractive…

A: According to the question,Consider a step index multimode fiber with a core diameter of…

Q: the signal X) t10-t) Assume that the available carrier frequency is 4MHZ and you are allowed to…

A:

Q: The scattering parameters of a certain two-port network is measured to be 0.3 0.6 using 50 ohms…

A: According to the question, for the given S-matrix as shown belowThe characteristic impedance of the…

Q: (a) A 2 PSK modulates the phase of the carrier AСos2fct so that binary 1 corresponds to 0 rad phase…

A: To do: a) we have to explain the modulation and coherent detection of BPSK. b) we have to…

Q: Q2. In a DSB-SC AM system, the carrier is e(t) = 0.5 cos (20000 nt) and the message signal is given…

A:

Q: Derive the scattering parameters for the circuit shown in Figure below. When jX, = 75 N; jX, = 25 Q,…

A: Converting given circuit into ABCD parameter -:  A  = 4 Ω   ,    B = 75 Ω    ,   C = 0.04 Ω    ,…

Q: 3.16 An SSB-AM signal is generated by modulating a 600 kHz carrier by the signal m(t) = sin 3000nt +…

A:

Q: In Frequency Hopping Spread Spectrum, if you knew that the bandwidth B =125MHz and Bss is 500MHZ,…

A:

Q: wavean m

A:

Q: 16.a. A signal in a fiber optic cable loses 69% of its power as it travels through the cable. What's…

A:

Q: 3.16 An SSB-AM signal is generated by modulating a 600 kHz carrier by the signal m(t) = sin 3000nt +…

A:

Q: If the analog signal travels over a transmission medium and its input voltage is 5 volts and output…

A: Given : Vin=5 V Vout=2.5V ANEXT=37dB

Q: An AM signal in which the carrier is modulated 70% contains 1500 W at the carrier frequency.…

A:

Q: Q3) A DS spread-spectrum system transmits in the presence of a tone interference using the spreading…

A:

Q: Given the signal x(t) = 4 cos( 2m10°t) Assume that the available carrier frequency is 4MHZ and you…

A:

Q: Calculate the first two pairs of sidebands for an FM signal, if the carrier frequency is 107MHz, and…

A: Given, An FM modulating signal is having  Carrier frequency, fc = 107 MHz Modulating signal…

Q: A spectrum analyzer is used to measure the magnitude of a certain signal with respect to its…

A: The modulation depth is also known as Modulation scheme. Which can be expressed as the extent of…

Q: Problem 7. (E06) Modulation Property of the LT: Let X(s) A L {x(t)} with ROC R and let wo, o € R.…

A: Given, Laplace Transform of x(t) is X(s) with ROC Rx. Show that L{x(t)cos(wot+φ)} =…

Q: 11.a. The total loss in a fiber link is 7.1 dB, the design margin is 1 dB, and the optical budget in…

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: (a) Prove that when a carrier is sinusoidally amplitude-modulated by a signal of lower frequency,…

A: According to the question, (a) Prove that when a carrier is sinusoidally amplitude-modulated by a…

Q: P Calculate the, modulation Coefficient and present modulation a Calculate the peak amplitude of the…

A:

Q: PAM signal can be extracted by using_. PWM LPF PLL HPF The AM spectrum consists of: * All of the…

A: 1) LPF  PAM signal can be extracted by using low pass filter.

Q: For a category-5e twisted pair the far end cross talk is if the cross-talk near the receiver 10 dB…

A: Far-end crosstalk (FEXT) is measured at the far end of the channel. It is detected to the opposite…

Q: Consider the AM modulated waveform shown below:   Find the modulating signal frequency, and the…

A:

Q: Consider an example that relates the Nyquist and Shannon formulations. Suppose the spectrum of a…

A: Ans : Given Channel bandwidth = 16-4 Mhz B =2 Mhz SNR = 30 dB  = 103Now ,A) Channel capacity C =B…

Q: We would like to transmit information over a CAT-6 twisted pair cable with a bandwidth of 250 MHz.…

A:

Q: Q1/ If the message signal is m(t) = cos (1000nt)cos (3000nt): a. Sketch the spectrum of m(t). b.…

A: Given : 3) m(t)=cos1000πt cos3000πt

Q: For a baseband signal m(t) = cos(2pi*f_m*t + pi/3). Find the DSB-SC and sketch its spectrum,…

A:

Q: A) What will happen to a propagating signal when the interconnect has frequency-dependent losses?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: An FM transmitter is determined to have a transmitter sensitivity of 287.874Hz/V. If the modulating…

A: modulation index = frequency sensitivity ×peak amplitude of modulating signalfrequency of…

Q: Find the power efficiency of an AM wave for a modulation index of 0.3?

A: For an amplitude modulated (AM) wave, the power efficiency is defined as the ratio of the useful…

Q: Discuss the design of modern transmission fibres with respect to effective area and chromatic…

A: It is asked to discuss the design of modern transmission fibers with respect to effective area and…

Q: A given amplitude modulated - large carrier (AM- DSB-LC) signal contains a carrier average power of…

A: The solution is given below

Q: An SSB-AM signal is generated by modulating an 800 kHz carrier by the signal m (t) = cos 2000nt +2…

A: For any signal x(t), the Hilbert transform of x(t) can be obtained by introducing a phase shift of…

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.