A 15.0% by weight solution was prepared using 90.0g of KCl and the resulting density of the solution is 1.101g/mL. (MW KCl 74g/n). volume of solution(mL)? milliosmole of solute? %w/v? weight of solvent(g? N?

Fluoridation of city water supplies has been practiced in the United States for several decades. It is done by continuously adding sodium fluoride to water as it comes from a reservoir. Assume you live in a medium-sized city of 150,000 people and that 660 L (170 gal) of water is used per person per day. What mass of sodium fluoride (in kilograms) must be added to the water supply each year (365 days) to have the required fluoride concentration of 1 ppm (part per million)that is, 1 kilogram of fluoride per 1 million kilograms of water? (Sodium fluoride is 45.0% fluoride, and water has a density of 1.00 g/cm3.)

Dimethylglyoxime [DMG, (CH3CNOH)2] is used as a reagent to precipitate nickel ion. Assume that 53.0 g of DMC has been dissolved in 525 g of ethanol (C2H5OH). s The red, insoluble compound formed between nickel(II)ion and dimethylglyoxime (DMG) is precipitated when DMG is added to a bask solution of Ni2+ (aq). (a) What is the mole fraction of DMG? (b) What is the molality of the solution? (c) What is the vapor pressure of the ethanol over the solution at ethanols normal boiling point of 78.4 C? (d) What is the boiling point of the solution? (DMG does not produce ions in solution.) (Kbp for ethanol = +1.22 C/m)

6-37 Calculate the w/v percentage of each of these solutes: (a) 623 mg of casein in 15.0 mL of milk (b) 74 mg of vitamin C in 250 mL of orange juice (c) 3.25 g of sucrose in 186 mL of coffee

Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as follows to reach 100. mL of solution: 285315 mg Na+ 14.117.3 mg K+ 4.9Q.O mg Ca2+ 368408 mg Cl 231261 mg lactate, C3H5O3 a. Specify the amount of NaCl, KCl, CaCl2 2H2O, and NaC3H5O3 needed to prepare 100. mL lactated Ringers solution. b. What is the range of the osmotic pressure of the solution at 37C, given the preceding specifications?

A solution is made by dissolving 34.0 g of NaCl in 100 g of H2O at 0C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated

A compound has a solubility in water of 250 mg/L at 25C. Should this compound be characterized as a soluble or insoluble compound at 25C?

Predict the relative solubility of each compound in the two solvents, on the basis of intermolecular attractions. (a) Is Br2 more soluble in water or in carbon tetrachloride? (b) Is CaCl2 more soluble in water or in benzene (C6H6)? (c) Is chloroform (CHCl3) more soluble in water or in diethyl ether [(C2H5)2O]? (d) Is ethylene glycol (HOCH2CH2OH) more soluble in water or in benzene (C6H6)?

Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)

A tree is 10.0 m tall. (a) What must be the total molarity of the solutes if sap rises to the top of the tree by osmotic pressure at 20 C? Assume the groundwater outside the tree is pure water and that the density of the sap is 1.0 g/mL. (1 mm Hg = 13.6 mm H2O.) (b) If the only solute in the sap is sucrose, C12H22O11, what is its percent by mass?