A 12 kW, 4 pole DC generator with a lap wound armature has 132 slots with each slot having 4 conductors. The pole flux is 0.05 Wb and the rotor speed is 1750 rpm? Determine the full load current flow out of the armature. Give the number value only, no units. Add your answer

A 12 kW, 4 pole DC generator with a lap wound armature has 132 slots with each slot having 4 conductors. The pole flux is 0.05 Wb and the rotor speed is 1750 rpm? Determine the full load current flow out of the armature. Give the number value only, no units. Add your answer

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Describe the similarities in the construction of a DC motor and a DC generator.

A: From a mechanical standpoint, a DC motor and a DC generator are quite similar, but from a technical…

Q: 4. The de shunt generator is connected to a load that draws 28,800 watts, given the armature and…

A: In the question 4, we need to calculate the generated emf. We know output power Po= VI Where V…

Q: A four-pole Shunt connected generator has a lap connected armature with 728 conductors. The flux per…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: An 8 pole, lap connected armature has 500 conductors has the flux per pole is 20 mWb is driven at…

A: For lap connected armature, Number of parallel path ( A ) = number of pole

Q: 1. A 500 V, 250 kW, long shunt compound generator induces an e.m.f. of 480 V when running at 1000…

A: As per BARTLEBY GUIDELINES, For Multiple Questions, we have to answer only first question. So I…

Q: ih 16 A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding…

Q: A 4 pole generator with wave wound armature has 54 slots each having 26 conductors. The flux per…

Q: A 4 pole DC shunt generator with 800 duplex wave connected armature conductors supplies a load of…

Q: In the DC shunt generator, the induced voltage in idle operation is 127V. Output voltage when loaded…

Q: A d.c. series generator has armature resistance of 0.5 ohms and series field resistance of 0.03 ohm.…

A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC…

Q: 1- A 6 pole lap-connected de generator driven at 1000 rpm, the useful flux per pole is…

A: An electrical machine where mechanical to electrical energy conversion takes place is called d.c.…

Q: a) What would be the speed of the armature, if flux per pole is 0.007 Wb? b) If the armature is…

A: Given, Number of poles (p) =6 Number of slots=50 Each slot contains 20 conductors. Hence total…

Q: 1. A 500 V, 250 kW, long shunt compound generator induces an e.m.f. of 480 V when running at 1000…

A: Given that: Terminal voltage Vt=250 V Full load armature current Ia=40 A Friction windage loss,…

Q: A 3-phase, 6-pole, 60-Hz, Y-connected AC generator has a stator with 48 slots, each slot contains 20…

Q: A 230 V dc shunt generator delivers 150A with friction loss of 1200W. The armature shunt field…

Q: 2. A four-pole shunt generator has a wave connected armature with 728 conductors. The flux per pole…

A: for generator , generated emf = terminal voltage + voltage drop in armature resistance . and…

Q: A shunt DC generator has no load terminal voltage of 140V. Armature resistance is 1ohm and shunt…

Q: In a 4 pole, 20 kW, 200 V wave wound DC shunt generator, the current in each parallel path will be

Q: The DC shunt generator with the terminal voltage 350 V, armature drop 7 V and the each brush drop 2…

Q: 16 A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding consist…

A: DC shunt generator No of pole 2 Speed N= 1200 rpm Flux per pole 0.03 No of turns 200 No of…

Q: An 10-pole d.c. generator has 585 armature conductors, and a useful flux of 46 mWb per pole. What…

Q: 5. URS Electrician has a 25 kW series generator used in street lighting has an efficiency of 85 8…

Q: A 4-pole generator has 36 slots with 10 conductors/slot. The flux and speed are such that an average…

A: The solution is given below

Q: Question 1. A DC series generator has armature resistance of 0..25 ohm and series field resistance…

Q: An 6-pole d.c. generator has 475 armature conductors, and a useful flux of 16 mWb per pole. What…

A: We need to find out generated emf for given machine .

Q: The DC shunt generator with the terminal voltage 300 V, armature drop 7 V and the each brush drop 4…

A: In this we will find emf..

Q: A dc series generator is supplying a current of 5 A to a certain load. The terminal voltage is 500…

Q: A 6 pole D.C. shunt generator has 60 slots on its armature. Each slot contains 15 conductors, 0.3…

A: Solution: D.C. shunt generator pole P=6, slot = 60 15 conductors/slot, armature resistance…

Q: Q choose the correct answer: 1-Brushless excitation system consisting of.... a- Stator field winding…

A: Given

Q: A 4 pole machine generates 250 volts when operated at 1500 rpm. If the flux per pole is 1.85 x…

A: It is given that: P=4Ea=250 voltsN=1500 rpmϕp-p=1.85×106 maxwell=1.85×106×10-8WbA=2no. of armature…

Q: A 250 V d.c. shunt generator has 1250 watts constant loss. Find out load current at maximum…

Q: A-6 pole generator has a lap-wound armature with 40 slots with 20 conductors per slot. The flux per…

A: Given: A generator having Number of poles, P=6 For lap would armature, A=P=2 Number of slots, S=40…

Q: A 12 pole generator has a lap wound armature with 78 slots with 40 conductors per slot. Then the…

A: Given generator has a lap wound armature, Total slots are 78,

Q: Flux is exactly proportional to L2 times field current in a d.c generator. The generator operates at…

A: In this question we need to find a e.m.f. produced. If the winding is wave wound, calculate the…

Q: (a) A 2 pole generator with wave wound armature has 85 slots each having 14 conductors. The flux per…

A: Generated EMF=Flux×speed×Number of conductors60×No. polesNo. of parallel paths. For Lap winding No.…

Q: 2. A long shunt compound generator has the following parameters: R = 0.05 №2, R = 0.1 22 and R = 150…

A: Given that: A long shunt compound generator has RSe=0.05 ohm, RSh=150 ohm, and Ra=0.1 ohm. Load…

Q: Q2-A 4 pole lap-wound, 900 r.p.m shunt generator has armature and field resistances of 0.442 and…

Q: Q8) A two-pole de generator has an armature containing a total of 40 conductors connected in two…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

A 12 kW, 4 pole DC generator with a lap wound armature has 132 slots with each slot having 4 conductors. The pole flux is 0.05 Wb
and the rotor speed is 1750 rpm? Determine the full load current flow out of the armature. Give the number value only, no units.
Add your answer
Integer, decimal, or E notation allowed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determination of given parameters,

VIEW

Step 2: Calculation of full load current,

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(B)-ndicate whether the following statements are true or false and correct the faise statements. -When a series d.c. motor is operate without load, the armature will not run. The strength of magnetic field in d.c. shunt generator can be varied by varying the polarity of the field poles The main disadvantage of series generators is Output voltage varies as the Toad varies There is no output from the transformer under short-circuit conditions
A 20-kW 220-volt shunt generator has an armature resistance of 0.07 ohm and a shunt resistance of 200 ohms.Determine the shunt field current A. 0.1 A B. 1.1 A C 2.1 A D. None of these
Question 2 Not yet answered Marked out of 2.00 P Flag question A 6 pole generator with wave wound armature has 56 slots each having 22 conductors. The flux per pole is 0.01 Wb. (i) At what speed must the armature rotate to give an induced EMF of 235V is, (ii) What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed is,
(a) A 6 pole generator with lap wound armature has 135 slots each having 14 conductors. The flux per pole is 20 mWb. At what speed must the armature rotate to give an induced EMF of 210V. (b) What will be the voltage developed, if the winding is wave connected and the armature rotates at the same speed
The DC shunt generator with the terminal voltage 300 V, armature drop 8 V and the each brush drop 2 V, then the value of generated emf is
A 2 pole wave wound dc generator has 44 slots, each slot having 20 conductors. The flux/pole is 0.018 weber. At what speed the armature be rotated to get an induced emf of 220 V. What will be the induced emf developed if the armature winding is lap connected and runs at the same speed. Speed Generated Emf when lap connected
A 3-phase, 6-pole, 25 Hz, Y-connected AC generator has a stator with 48 slots, each slot contains 20 conductors. The coils of each phase are connected in series. The flux density is 0.5 T. What is the speed of rotation of the stator magnetic field in RPM? Answer: The speed is: RPM.
A six-pole dc machine has an armature connected as a lap winding. The armature has 32 slots with six conductors per slot. The armature is rotated at 600 rpm, and the flux per pole is 30 mWb. Calculate the induced voltage. 1
A 6 pole generator with wave wound armature has 58 slots each having 20 conductors. The flux per pole is 0.01 Wb. () At what speed must the armature rotate to give an induced EMF of 230V is, GD What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed is,
State two reasons why a self-excited shunt dc generator may fail to build up a voltage. In each (both) case, briefly explain what can be done to correct the problem. Reason #1 Solution #1 Reason #2 Solution #2
The DC shunt generator with the terminal voltage 375 V, armature drop 6 V and the each brush drop 4 V, then the value of generated emf is