A 12 kVA, 58HZ, single-phase transformer has a turns ratio of 10:1 and is supplied from a 2.8 kV supply. Neglecting losses, determine (a) the secondary voltage, (b) the full load secondary current, (c) the maximum flux and (d) the minimum value of load resistance which can be connected across the secondary winding without the kVA rating being exceeded. Secondary voltage Secondary Current Maximum Flux

A 12 kVA, 58HZ, single-phase transformer has a turns ratio of 10:1 and is supplied from a 2.8 kV supply. Neglecting losses, determine (a) the secondary voltage, (b) the full load secondary current, (c) the maximum flux and (d) the minimum value of load resistance which can be connected across the secondary winding without the kVA rating being exceeded. Secondary voltage Secondary Current Maximum Flux

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a single phase transformer, when no-load voltage is 230V and full load terminal voltage is 220, then the percentage regulation is 4.54%. Select one: True False
Q6 Complete the answer : If connected .................... to the transformer changes, copper loss varies.
In no load phasor diagram of practical transformer, the magnetizing current is with flux 4. In phase 90 Degree out of phase Lagging by 60 Degrees Leading by 60 Degrees
Justify if in a Yy transformer (without neutral wire on the supply side) there are homopolar components in fluxes, voltages and currents, and indicates whether this operation is satisfactory or not
In a single phase transformer, when no-load voltage is 230V and full load terminal voltage is 220, then the percentage regulation is 4.54%. Select one: True False
A 5750 V/ 260 V, 50HZ single-phase transformer is to have an approximate e.m.f. per turn of 35 V and operate with a maximum value of flux density of 1 T. Calculate (a) the number of primary turns (b) number of secondary turns (c) maximum value of flux and (d) the cross-sectional area of the core. Number of turns in Primary Number of turns in Secondary maximum value of flux Area of cross section
Why we used isolation transformer
In no load Phasor diagram of practical transformer, the core loss current Ic is with primary voltage Vp. O Lagging O in phase O Leading O 90 degrees out of phase
A 3.5 kV / 120V, 50 Hz, single phase transformer is to have an approximate e.m.f per turn of 33V and operate with a maximum flux density of 1.35T. Determine, (a) The number of primary and secondary turns. (b) The cross sectional area of the core.
calculate the iron loss P; and copper loss Peu of each transformer for full load condition.
A single-phase 626 V/ 1932 V, 54 Hz transformer has a maximum core flux density of 2 Tesla and an effective core cross-sectional area of 39 cm² Determine the number of primary turns.