A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of compensating winding turns per pole is .approximately equal to if the ratio of pole arc/pole pitch is 0.72 ---- 36 18 16 none of the mentioned.

A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of compensating winding turns per pole is .approximately equal to if the ratio of pole arc/pole pitch is 0.72 ---- 36 18 16 none of the mentioned.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Flashing the field of a direct current generator implies Neutralising residual magnetism…

A: Flashing the field of a direct current generator implies that

Q: A 6 pole, 3.3 kV, 50 Hz dalta -connected three-phase induction generator has the following…

Q: Out of the following four sources of losses in a dc generator which one is minimum? O Copper losses…

A: We need to select correct option for losses in dc generator .

Q: 1. Variable loss in a dc series generator = la2 Ra. 2. Lap winding is suitable for high current,…

A: The explanation is as follows.

Q: T-a. The direction of rotation of a single-phase split-phase motor can be change by........ a)…

A: According to guidelines we need to solve only the first question. According to the question, define…

Q: To change the direction of rotation of a series wound DC generator the general rule is to

A: To change the direction of rotation of a series wound DC generator Note: we always change the…

Q: A 6-pole, 3-phase AC generator has 12 slots per pole and four conductors per slots. The winding is…

A: It is given that: Number of poles=P=6Number of phases=m=3Number of slots=S=12Number of conductors…

Q: A DC generator has armature emf of 200 V when it works on full flux/pole 40 mWb, and speed of 500…

A: Given: For the 1st DC generator, EMF, E1=200 V Flux, φ1=40 mWb. Speed, N1=500 rpm. For the 2nd DC…

Q: The internal characteristics of DC shunt generator can be obtained from *

A: Internal characteristics of DC shunt generator obtained by the relationship between the generated…

Q: A dc generator is run at 500 rpm. The eddy current losses and hysteresis losses are found to be 100…

Q: A long shunt compound generator delivers 100A, 250V at rated load. The resistances of the various…

A: In this question We need to determine overall efficiency of the generator. the A long shunt compound…

Q: 1.Two identical shunt generators running in parallel, each with armature resistance of 0.02 ohms and…

Q: 4. A short-shunt compound generator has armature, shunt-field and series-field resistances of 0-8 2,…

Q: What will be the front and back pitches of the 6-pole dc generator with a simplex 2-layer wave…

Q: Ih a d.c generator flux is directly proportional to L2 times field current.The generator is working…

Q: The terminal voltage of a 150kW series generator is 600V at rated load. Determine the efficiency if…

Q: Four compound generators operating in parallel supply a load of 1,000 A. The resistance of series…

Q: 1. Variable loss in a dc series generator = la2 Ra. 2. Lap winding is suitable for high current,…

A: Will consider each statement separately.

Q: The number of poles in the rotor circuit of a 3-phase induction motor is O Always two. Zero, because…

Q: A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance…

A: Rsh = 200 Rse = 1 ohm Ia = 10 A

Q: the percentage change in termin

Q: PZ 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is…

Q: 4 Pole generator has a wave wound armature with 32 conductor per slot. The flux per pole is 40mWb…

Q: In a 4 pole, 20 kW, 200 V wave wound DC shunt generator, the current in each parallel path will be

Q: A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of…

A: The solution can be achieved as follows.

Q: A single-phase 111-V, 50-Hz supply is connected to a coil with 200 turns of a coil-core assembly as…

A: Given, Single phase transformer. Single phase supply voltage, e=111 V. Frequency, f=50 Hz. Number…

Q: The frequency of voltage generated in SG depends on: Select one: a. Number of poles b. number of…

A: The synchronous speed of SG is So the frequency of voltage generated in SG depends on number of…

Q: A 4 pole generator with wave wound armature has 55 slots each having 25 conductors. The flux per…

A: From the DC generator

Q: A short shunt compound generator supplies a load of 20 kW at 500 V. The armature, series and shunt…

A: Load current = power delivered to load/ terminal voltage voltage. Power developed = armature…

Q: ndard practice of synchronous generator construction now a days is to ndrical field ating armature…

A: These are the few questions related to the basic understanding of alternators their construction and…

Q: d.c. shunt generators in parallel, ench having an armature resistance of 0.1 0, running at the same…

Q: 12. Calculate the number of series turns per pole required on a compo generator to enable it to…

Q: The compensating winding operation aid the commutating winding operation True False

A: Compensating windings are used to overcome the commutation and cross-magnetization effect of…

Q: A short shunt compound generator delivers 150A at a terminal voltage is 230V. The shunt field…

Q: A 4 pole dc shunt generator with a shunt field resistance of 100 ohm and an armature resistance of 1…

A: We have given;pole P=4shunt filed resistance=100Ωarmature resistance=1Ωz=378flux per pole…

Q: winding

Q: A 4-pole, wave of 300 turns eac

A: Generally there are two types of winding configuration is used for DC machine: Lap winding and wave…

Q: d. Winding table ( e. Winding diagram (

A: Turn per coil = 1Conductor per slot = 2Commutator segments = 25To create a winding table for a…

Question

h 13
A 100kW generator, 25OV, 6 poles have a wave wound armature with 300
turns then the number of compensating winding turns per pole is
.approximately equal to
if the ratio of pole arc/pole pitch is 0.72
36 O
18
16
none of the mentioned. )
8.
50

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For DC shunt generator, external characteristics is the relationship between Answer:
A DC 4 pole lap wound generator is running at 1000 rpm having 1200 conductors and flux density is 10 mwb. find the generated emf?
A-6 pole generator has a lap-wound amature with 40 slots with 20 conductors per slot.The flux per pole is 25mWb.The terminal voltag is 288V and the voltage regulation of the generator is 4%. Determine the speed of the generator
q4
In DC shunt generator, the load characteristics is drawn between
The open-circuit characteristic of a DC generator is also called as characteristics. O internal O performance external O no load saturation
10- A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then series field current is a. 10A b. 9A c. 1A d. 2A
C 4 Pole generator has a lap wound armature with 30 conductor per slot. The flux per pole is 30mWb and the speed of the generator is 960rpm. Find the total number of slots to generate an EMF of 316.8V.
Please solve this problem step by step and illustrate your answer properly. Write your answer in a piece of paper please. Box the final answer.
How does a circuit breaker work in a power system, and what is its role in protecting the system from faults?
6
A 4 pole generator with wave wound armature has 54 slots each having 28 conductors. The flux per pole is 0.01 Wb. () At what speed must the armature rotate to give an induced EMF of 220V is, (i) What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed is,