A, = 1000 mm2 Q.3) A steel rod ABC is firmly held between two rigid supports A and C as shown in the figure. If the rod is heated through 30°C then the stress developed in portion AB of the rod will be (Take a = 12 × 106ºC and E = 200 GPa) (A) 43.84 MPa (C) 100.8 MPa A, = 500 mm? B 0.6 m 0.8 m (B) 50.4 MPa (D) 54.75 MPa

Q: 2. The setup for an experiment consists of a curved steel beam with a rectangular cross section…

A:

Q: Why As is like 2(pi/4)d^2 This question asks for the average tension only in section a-a, is that…

A: As we can see that section a-a will be in shear and not in tension.

Q: Complete answer

A: Given Data: Diameter of OB and AB (D) = 100 mm = 0.1 m Radius of disc (r) = 0.5 m Allowable normal…

Q: Determine the largest weight W that can be supported by the wires shown in figure. The stress in…

A:

Q: The inner diameter of a cylindrical pressure vessel is 400 mm. When subject to pressure, the hoop…

A:

Q: The rigid beam is supported a pin connection at A and a cable BD at point the. Diameter of pin at A…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: A solid steel bar with a diameter of 50 mm is subjected to three forces as shown in the figure,…

A: In the given problem, the main stresses will be developed at point B due to 1200N force which will…

Q: Problem: A horizontal steel wire AB is stretched between rigid supports. The initial pre-stress in…

A: Given data: σ=48 MPaTi=15°Cα=12×10-6 /°CE=200 GPa Need to determine the temperature when the stress…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.