Q1: Resolve the following problems.Exercise 1:A 100 load resistance is connected across a half wave rectifier.The input supply voltage is 220 (rms) at 60 HZ.Dtermine the DC output (verage) voltage peak to peak ripple in the output voltage (Vpp), andthe output ripple frequency (fr).Exercise 2:Consider the circuit as shown below and assume the diode to be ideala.Give the equivalent circuitb. Calculate the current through 48 ohm resistor in the circuit.D48 N10 vD,D,

We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Answered: A 100 load resistance is connected…

Similar questions

An RLC series circuit consists of a 10-N resistor, an 8.0-uF capacitor, and a 50-mH inductor. A 110-V (rms) source of variable frequency is connected across the combination. What is the power output of the source when its frequency is set to one-half the resonant frequency of the circuit?
In an AC circuit containing a resistance load only:a. Does the current reach its maximum peak value at the same instant in timeas does the voltage?b. Does the current reach its minimum value at the same instant in time as doesthe voltage?
The change in output voltage, SE, from a 1/4 arm Wheatstone bridge circuit is 299 micro-volts. Determine the measured micro-strain assuming a gauge factor of GF-2.012, and an input voltage of 10 volts.
An circuit connected to an AC source has a load of resistance R. When time is 7.00 ms the current through the circuit reaches 60% of the peak current. Calculate the lowest source frequency when this happens.
A series R-L-C circuit, where the components had the following values: RS = 10 Ω , Rexp = 110 Ω, C = 1 μF, and L = 980 ?H. Calculate the expected value of the circuit’s resonant frequency, f0.
The series RLC circuit below has an input voltage of Vin(t) = 16 cos(5t) Volts. 2 H Vin .1 F a) Solve for the steady-state voltage across the capacitor, Vc(t). CdV instead of solving b) Find the steady-state current. (This can be done by using I = another ODE. If you want, you can check that these give the same answer.)
The peak voltage of an AC source is 102 V. What is the rms voltage?
B7
you have a series RLC cir cuit made witha Resistor R=43-0 r, indactor L=27:0 MH, and capacibor C= 16-0nF. The Circuit is ariven by an AC source with Vems = 15.0V at Frequency f=7-90 KHZ- what is the RMS Voltage Ni across the inductor ? what is the RMS voltage AVC across the capacitor? %3D
b) A full wave rectifier produces 80 V peak rectified voltage from 60 Hz AC source. If a 10 µF filter capacitor is used, determine the ripple factor for a load resistance of 10 k N.
A 45.8 F capacitor is connected to a 6.2 V, 208 Hz source. What is the capacitive reactance (in ohms)?
The reactance of a capacitor is 78 when the frequency is 440 Hz. What is the reactance when the frequency is 860 Hz?

SEE MORE QUESTIONS

A 100 load resistance is connected across a half wave rectifier. The input supply voltage is 220 (rms) at 60 HZ. Dtermine the DC output (verage) voltage peak to peak ripple in the output voltage (Vpp), and the output ripple frequency (fr).