A 100 kVA, 380 V, 50 Hz, Y-connected synchronmous generator was tested with a rated field crent value of 3A and open circuit terminal voltage was measured as VT,oc-400 V and short circuit line current was measured as Ih,sc=220 A for this conditions. When a DC voltage of 20 V was applied to two of the terminals (between the ends of two phase coils), a current of 20 A was measured as a phase coil current. Under the given conditions, find the internal generated voltage (Ea=?), stator resistance (Ra=?) and synchronous reactance (Xs=?) values if the field current was applied with its rated value

A 100 kVA, 380 V, 50 Hz, Y-connected synchronmous generator was tested with a rated field crent value of 3A and open circuit terminal voltage was measured as VT,oc-400 V and short circuit line current was measured as Ih,sc=220 A for this conditions. When a DC voltage of 20 V was applied to two of the terminals (between the ends of two phase coils), a current of 20 A was measured as a phase coil current. Under the given conditions, find the internal generated voltage (Ea=?), stator resistance (Ra=?) and synchronous reactance (Xs=?) values if the field current was applied with its rated value

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.33P: Consider the three single-phase two-winding transformers shown in Figure 3.37. The high-voltage...

See similar textbooks

Similar questions

The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8 ohm. The effective resistance per phase is?
4- With the increase of the winding of a d.c. generator, terminal voltage will: c) Remain same a) Decrease b) Increase d) None of these
Draw the complete circular stator winding for a three phase delta connected AC generator consisting of 4 poles and 24 slots using a parallel connection. Your submission must consist of two drawings as follows: One drawing must show the winding arrangement of the phasegroups in the slots of the stator highlighting the start and finish of each phasegroup The other drawing must show only the end connections of each phase group for a parallel connection of the phasegroups and a delta connection of the phases
(A 100 kVA, 380 V, 50 Hz, Y-connected synchronmous generator was tested with a rated field current value of 3A and open circuit terminal voltage was measured as V₁,0c-400 V and short circuit line current was measured as IHSC-220 A for this conditions. When a DC voltage of 20 V was applied to two of the terminals (between the ends of two phase coils), a current of 20 A was measured as a phase coil current. Under the given conditions, find the internal generated voltage (E₁-?), stator resistance (RA-?) and synchronous reactance (XS-?) values if the field current was applied with its rated value. Be careful about your solutions to be written readable and write the answers inside the boxes as it was shown below.) RA Xs= EAF
Why are alternators connected in parallel? What are the conditions for parallel connection? Explain.
Two compound generators are operated in parallel. If generator A has a series-field resistance of 0.0015 ohm is adjusted to take 30 percent of the line load while generator B with a series field resistance of 0.001 ohm takes the remainder of the load, determine the current flow in the two series fields and the equalizer when the load is 230 kw at 230 volts.
A synchronous generator runs at 250 rpm and generators at 60HZ. There are 240 slots each containing 5 conductors arranged in full-pitched winding for three-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load distributed sinusoidally over the pole pitch is 2.5 x106 Maxwell. What is the emf induced in each winding and the terminal voltage?
Explain! The main disadvantage of using short pitch winding in alternators is that it Reduces the harmonics in the generated voltage Reduces the total voltage around the armature Produces asymmetry in the three phase windings Increases Cu of end connections
Please solve d, e, f ONLY.
Is there a difference between the phase windings resistances, if so, what does it mean? Please explain.
A 6 pole, 3.3 kV, 50 Hz dalta -connected three-phase induction generator has the following equivalent circuit parameters: R1 = 0.5Ω, R2' = 0.4Ω,X1 = 1.8Ω, X2' = 1.5Ω, Xm and R0 are large enough to be ignored. The generator is operating at a slip of -0.05. Determine the output real and reactive power, the generator power losses, the input mechanical power and the generator efficiency.
An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each containing 5 conductors. The winding is distributed and full pitch. All the conductors of each phase are in series and flux per pole is 30 mWb which is sinusoidal distributed.Calculate the number of pole.