A 10-hectare rice land is to be irrigated at the peak water requirement of 10 mm/day. The source of water is pump from a river with outlet discharge directly to the irrigation canal. If the pump operates at 10 hours per day, what should be the capacity of the pump? What should be the size of engine if the total dynamic head is 10 meters. Assume pump efficiency to be 80 percent and engine to be 75 percent.

Q: An outward flow reaction turbine has inner and outer diameter of the wheel as 1 m and 2 m…

A:

Q: The variation of pump head, efficiency, and required ENPY parameters with flow rate obtained from…

A:

Q: A pump has a displacement of 65 cm³/rev and is driven by a 37.3 kW electric motor at 1775 rpm. If…

A:

Q: A 20-KW motor with 80% efficiency drives a centrifugal pump delivery 0.08m3/sec against a head of…

A: Introduction The efficiency of the pump consequently, is never more than a hundred percent since…

Q: A centrifugal pump is to deliver 227 m³/hr of water from a source 4 meters below the pump to a…

A: Given data: A centrifugal pump delivers 227 m3/hr of water from a source 4 meters below the pump…

Q: 50 lb. and the At the instant shown (0-60°), the kid has a velocity of 10 ft/s. The weig weight of…

A:

Q: discuss in great detail the different pump curves including supply curve, system curve and…

A:

Q: Thirty (30) liters/second of stream water must be pumped up a vertical height of 12 meters to…

A: Water flow rate, Q=30 Lit/s Water pumped to vertical height, H=12 m Pump efficiency, ηpump=62% Motor…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.