Answered: A 10 g ball bearing is placed at the… | bartleby

Related questions

Question

100%

A 10 g ball bearing is placed at the top of a loop de loop track 30 cm above the top of a table and
released from rest. After traveling through the track, the ball bearing rolls off of the table. If the
table is 1.10 m tall how far does the ball bearing travel before it hits the ground assuming that
air resistance and friction is negligible.

Expert Solution

Step by step

Solved in 6 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

So the question is a hoop rolls without slididng alng the ground with linear velocity of 10 m/s. A hoop has I= MR^2. It comes to a hill and starts going up. What vertical distance up the hill does it travel before it stops? Assume there are no lossed to friction or air resistance.
A uniform drawbridge must be held at a 37° angle abovethe horizontal to allow ships to pass underneath. The drawbridge weighs45,000 N and is 14.0 m long. A cable is connected 3.5 m from thehinge where the bridge pivots (measured along the bridge) and pullshorizontally on the bridge to hold it in place. What is the angular speed of the drawbridge as it becomes horizontal?
In the figure, two 6.20 kg blocks are connected by a massless string over a pulley of radius 2.40 cm and ro- tational inertia 7.40×10-4 kgcdotm?. The string does not slip on the pulley; it is not known whether there is friction between the table and the sliding block; the pulley's axis is frictionless. When this system is relea- sed from rest, the pulley turns through 0.650 rad in 91.0 ms and the acceleration of the blocks is constant. What are (a) the magnitude of the pulley's angular acceleration, (b) the magnitude of either block's acce- leration, (c) string tension Tı, and (d) string tension T2?
A turnable with a moment of interia of 0.012 kg m² rotates freely at 2.0 rad/s. A circular disk of mass 200 g and diameter 30 cm, and initially not råtating, slips down a spindle and land on the turnable. (A) Find the new angular speed. (B.) Whot is the change in kinetic energy?
Suppose partial melting of the polar ice capsincreases the moment of inertia of the Earth from 0.331 MERE2 to0.332 MERE2. (a) Would the length of a day (the time required forthe Earth to complete one revolution about its axis) increase ordecrease? Explain. (b) Calculate the change in the length of a day.Give your answer in seconds
A 750 g disk and a 760 g ring, both 15 cm in diameter, are rolling along a horizontal surface at 1.3 m/s when they encounter a 13 ∘ slope. How far up the slope does the disk travel before rolling back down? How far up the slope does the ring travel before rolling back down?
A 5,0 kg solid spherical ball rolling without slipping and initially moving with v=4.1 m/s climbs up the ramp. Calculate the maximum height it can reach before coming to stop.
A 8.6-cm-diameter, 389 g sphere is released from rest at the top of a 3.2-m-long, 25° incline. It rolls, without slipping, to the bottom. (a) What is the sphere's angular velocity at the bottom of the incline?
(a) What is the final velocity, in m/s, of a hoop that rolls without slipping down a 7.10 m high hill, starting from rest? m/s (b) What would be the final velocity, in m/s, if a disk of the same mass and radius as the hoop rolled down the hill? m/s