A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was fitrated against an unknown acid. The volumes of NaOH(aq) Strated are shown in the table below. Volumes of NaOH(aq): Second Third Reugh titration Fist titration Third titration titration titration Final burette reading: (ml) Initial burette reading: (ml.) 19.00 34.05 20.86 36.01 23.57 19.00 19.07 5.76 21.02 8.54 The molarity of the unknown acid is 0.08108 Mand the volume of the unknown acid used in each titration is 14.80 mL O Was the unknown acid monoprotic, điprotic or triprotic? Show your calculations and reasoning. (i) What type of chemical reaction is this?

A 0.9600 M NaOH solution was diluted with a factor of 4. Then the diluted solution of NaOH was fitrated against an unknown acid. The volumes of NaOH(aq) Strated are shown in the table below. Volumes of NaOH(aq): Second Third Reugh titration Fist titration Third titration titration titration Final burette reading: (ml) Initial burette reading: (ml.) 19.00 34.05 20.86 36.01 23.57 19.00 19.07 5.76 21.02 8.54 The molarity of the unknown acid is 0.08108 Mand the volume of the unknown acid used in each titration is 14.80 mL O Was the unknown acid monoprotic, điprotic or triprotic? Show your calculations and reasoning. (i) What type of chemical reaction is this?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The titration of a 5.00 mL sample of an HCl solution of unknown concentration requires 4.90 mL of a 0.1000 M NaOH solution to reach the equivalence point. What is the concentration of the unknown HCl solution in M?
A student performed titration to determine the concentration of citric acid with potassium permanganate solution. The net ionic equation is as follows: 5C6H8O7 + 18MnO4- + 54H+ → 30CO2 + 47H2O + 18Mn2+ The concentration of potassium permanganate soluiton is 0.266 M. The volume of lemon juice is 25.00 mL. The titration consumed 17.6 mL of potassium permanganate solution to reach the endpoint. Determine the moles of citric acid in the lemon juice sample.
A 71.0 mL sample of 0.0100 M HClO4 is titrated with 0.0200 M NaOH solution. Calculate the pH after the following volumes of base have been added. (a) 13.8 mLpH = (b) 35.1 mLpH = (c) 35.5 mLpH = (d) 36.6 mLpH = (e) 61.4 mL
In the titration of a 25.00 mL sample of the hypothetical monoprotic acid, CHEM, it took 20.41 mL of a 0.3625 M solution of NaOH to reach the equivalence point. What is the concentration of CHEM?
A 23.0 mL sample of a 0.425 M aqueous acetic acid solution is titrated with a 0.475 M aqueous sodium hydroxide solution. What is the pH at the start of the titration, before any sodium hydroxide has been added? ( Provide detailed solution.)
Suppose a student performed a similar standardization titration experiment. Below is the calculated concentration of NaOH from each of their titrations. Titration #1 Titration #2 Titration #3 The concentration of NaOH (M) 0.9554 0.9540 0.9551 Using the 3 concentrations, calculate the average concentration of the student's NaOH solution and calculate the ± error in parts per thousand (ppt). Show the complete calculation. Express your final answer in the form of average (with units) ± error in ppt.
Consider the “window cleaner” problem, question 2 on page 12 of your lecture notes. Suppose that prior to the titration, the 10 mL sample of window cleaner was diluted by adding about 10 mL of DI water so that the solution could have better contact with the pH meter. What effect would this dilution have on the volume of titrant needed? (a) The amount of titrant would be the same because the moles of analyte was not changed.(b) The amount of titrant would be doubled because the analyte solution volume was doubled.(c) The amount of titrant would be halved because the was diluted by half.
A 5.50 mL sample of an H3PO4H3PO4 solution of unknown concentration is titrated with a 1.050×10−2 MNaOH solution. A volume of 7.32 mL of the NaOH solution was required to reach the equivalence point. What is the concentration of the unknown H3PO4H3PO4 solution? Express your answer with the appropriate units. value/units
If 17.1 mL of 0 M NaOH are used, how many moles are in this sample? Suppose 0.371 grams of a solid monoprotic acid are titrated with 16.45 mL of 0.117 M NaOH. What is the molar mass of the solid acid?
A 28.00 mLmL sample of an H2SO4H2SO4 solution of unknown concentration is titrated with a 0.1422 MM KOHKOH solution. A volume of 43.22 mLmL of KOHKOH was required to reach the equivalence point. What is the concentration of the unknown H2SO4H2SO4 solution? Express your answer using four significant figures.
Determine the molarity of a 7.00 ml HCl solution if it takes 48.35 mL of a0.1315M NaOH solution to neutralize in a titration. HCl+NaOH-->NaCl +H2O
A 29.00 mLmL sample of an H2SO4H2SO4 solution of unknown concentration is titrated with a 0.1372 MM KOHKOH solution. A volume of 41.22 mLmL of KOHKOH was required to reach the equivalence point. What is the concentration of the unknown H2SO4H2SO4 solution? Express your answer using four significant figures.