A 0.65kg, 50m tape was standardized and supported throughout its whole length and found to be 0.00205m longer at an observed temperature of 31.8°C and a pull of 10KN. This tape was used to measure a 4% grade line which was found to be 662.702m. During measurement, the temperature is 15°C and the tape is suspended under a pull of 20KN. E-200GPa, cross-sectional area of tape is 3mm2 and the coefficient of linear expansion is 0.0000116m/°C. Compute the true horizontal distance.

A 0.65kg, 50m tape was standardized and supported throughout its whole length and found to be 0.00205m longer at an observed temperature of 31.8°C and a pull of 10KN. This tape was used to measure a 4% grade line which was found to be 662.702m. During measurement, the temperature is 15°C and the tape is suspended under a pull of 20KN. E-200GPa, cross-sectional area of tape is 3mm2 and the coefficient of linear expansion is 0.0000116m/°C. Compute the true horizontal distance.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Design a steel hollow column of length 15-m with minimum weight for a water tank such that it can carry a water tank of 45000 kg. The tank is to designed such that to withstand a ground vibration due to an earthquake. The earthquake excitation is idealized as undergoing a harmonic ground acceleration of amplitude of 0.5 g. The natural frequency of the water tank should exceed 20 Hz. Assume the Yield Strength for the steel to be 250 MPa. Assume a damping ratio of = 0.2. D 5(1)
Answer asap. will upvote
Asap plzzz
Utilice el método de castigliano para calcular la deflexion en el nodo C de la viga
The distance of the flag pole to the campus grounds was recorded as 440.37 m. A 50-m steel tape, of standard length at 20°C and 41 N, was used. During measurement, the temperature reading was 36°C with an applied pull of 57 N. Determine the correct distance of pole to the campus. Other properties of the tape is listed below: • cross-sectional area = 8.0 m² • modulus of elasticity= 200 GPa • K = 0.0000116/°C
Please help me ASAP. Please put the answer on the paper. Complete solution. I need the answer after 40 minutes. Rate will be given accordingly. Thank you in advance.Line AB was measured and the result is 745m. It is measured using a 30m tape that is0.005m tooshort. The tape is standardized at 20°C under a 4.5kg pull. During measurement the temperature is30°C under a pull of 9.57kg. What is the true horizontal distance of line AB due to incorrect tape length,temperature, and pull? The cross-sectional area of the tape is 0.05cm2 and E = 2x106 kg/cm2.
How was this 0.68 V2 calculated? And also 40.77 f V2 because I am not getting that..
Show full solutions.
Patm= lo1. 3 K h= 17 f = 1.23 Kg m9