Answered: A 0.2-kg mass on a spring executes…

A 0.2-kg mass on a spring executes simple harmonic motion at a frequency f. What mass is necessary for the system to vibrate at a frequency of 2f? * O 0.4 kg 0.18 kg 0.05 kg O 0.1 kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

mechanical principles Explain the natural frequency of vibration in a mass-spring system.
2- A spring-mass system has a mass (m) 63 Lbs and a stiffness of 150 Lb/in, find: Natural frequency (@) in Rad/s b. The natural frequency (f) in Hz. c. Period (T) in Sec. а.
The following mass-and-spring system has stiffness matrix K. For the mks values, find the two natural frequencies of the system and describe its two natural modes of oscillation. k₁ k₂ K3 K= - (K₁ + K₂) k₂ m₁ = 1, m₂ = 5; k₁ = 3, k₂ = 15, k3 = 15 k₂ - (K₂ + K3) Describe the mode of oscillation for w₂. Select the correct choice below and, if necessary, fill in the answer box to complete your choice. A. The two masses move linearly, staying a fixed distance apart. B. The two masses oscillate in the same direction, where the amplitude of m₁ is O C. The two masses oscillate in opposite directions, where the amplitude of m₁ is D. The two masses oscillate in the same direction with equal amplitudes. E. The two masses oscillate in opposite directions with equal amplitudes. times the amplitude of m2. times the amplitude of m₂.
A dynamic torsional system, consisting of five disks keyed to a 1 inch diameter steel shaft is vibrating freely at a natural frequency. An end disk has a moment of inertia, I1 of 5 in-lb-sec2 while the next one to it has a I2 of 10 in-lb-sec2. The distance between these disks is 8 inches. The amplitude ratio of these disks Theta1/ Theta2 is -2. Determine its natural frequency in cpm. Use G=12x106 psi.
In an oscillatory motion of a simple pendulum, the ratio of the maximum angular acceleration, e"max, to the maximum angular velocity, e'max, is t s^(-1). What is the time needed for the pendulum to complete two oscillations? 1 sec 0.5 sec 2 sec 4 sec 0.25 sec A simple pendulum is set into motion at two different times with different inltlal conditions. The first time: the bob Is in its equilibrium position and is given an neriod of nmotion is T1 The second time: the bob is In its equilibrlum position and inm height reached by the bob is initial veloclty 2 m/s The maximum helght reached by the bob is ht.max and the
In an oscillatory motion of a simple pendulum, the ratio of the maximum angular acceleration, O"max, to the maximum angular velocity, O'max, is 2t s^(-1). What is the time needed for the pendulum to complete two oscillations? 4 sec 1 sec 0.5 sec 2 sec 0.25 sec A simple pendulum is set into motion at two different times with different initial conditions. The first time: the bob is in its equilibrium position and is given an initial velocity +4 m/s. The maximum height reached by the bob is h1,max and the period of motion is T1. The second time: the bob is in its equilibrium position and tu12 m/c The maxinmum height reached by the bob is
Asimple harmonic oscillator is formed by attaching a 0.75kg mass to a horizontal spring. The mass is pulled 0.2m from its equilibrium position and the realeased from rest. Due to the effect of damping, after completing one full oscillation in 1.31 seconds, the mass's total energy is 93 % of its original energy. Determine the damping parameter b in standard SI units of kg/s
Solve step by step in digital form
A single degree of freedom spring mass system has a natural frequency of 10 cycles per second. Another single degree of freedom spring mass system is attached to it. The latter had a natural frequency of 20 cycles/second. What is the approximate fundamental frequency of composite system?
A vehicle is modelled as a combined mass-spring-damper system that oscillates in the vertical direction only. The driver of the vehicle travels along a road whose elevation varies sinusoidally as shown in Figure 2. The mass of the vehicle, which includes the driver, is 2500 kg. The stiffness and damping of the shocks are 40 kN/m and 3000 kg/s respectively. i. Determine the amplitude of vibration of the vehicle when it travels at a constant speed of 90 km/hr along the sinusoidal road. y/m 0.6 ►Velocity of vehicle m 0.4 ► Rigid massless tyre 0.2 distance (m) 20 60 80 -0.2 Figure 2
A block-spring system has a maximum restoring force Fmax = 0.1 N. If the amplitude of the motion is A = 0.01 m and the mass of the block is m= 400 g then the angular frequency w is equal to O 20 rad/s 2.5 rad/s O 10 rad/s O 1.25 rad/s O 5 rad/s A mass-sr
In the system below, the block has mass M = 2.0 kg, the spring has constant k = 500 N/m, and this spring-mass system is at rest. A projectile of mass m = 10g, with a speed of 800 m/s, collides with the block and becomes lodged inside. There is friction between the block and the floor on which it rests.a) What is the initial amplitude of the oscillation that the system acquires, right after the shock? Note: Assume the effect of friction on a single swing is negligible. b) Knowing that the amplitude is halved in 20 seconds, calculate the damping factor due to friction? c) How many oscillations, approximately, occurred in these 20 seconds?