9.23 It is relatively easy to design an efficient nozzle to accelerate a fluid. Conversely, it is very difficult to build an efficient diffuser to decelerate a fluid without boundary layer separation and its subsequent inefficient flow behavior. Use the ideas of favorable and adverse pressure gradients to explain these facts.

9.23 It is relatively easy to design an efficient nozzle to accelerate a fluid. Conversely, it is very difficult to build an efficient diffuser to decelerate a fluid without boundary layer separation and its subsequent inefficient flow behavior. Use the ideas of favorable and adverse pressure gradients to explain these facts.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q, nozzle.
A closed tank containing 2 layers of fluids is discharging its contents through an orifice as shown in the figure. The circular orifice has a diameter of 48mm with a discharge coefficient of 0.65. Considering a pressure reading of 148kPa on the surface of the fluids within the tank, determine the discharge flowing out of the orifice (in L/s)? The gasoline layer is 4.0m deep with a specific gravity of 0.69, while the water surface is 5.5m above the orifice. Air: kPa gage V Gasoline %3D D = mm Water
Fluid
(c) Liquid flows through an orifice in the bottom of a cylindrical tank at a velocity of 4m/s. If the jet diameter is 2.5cm, what is the rate of flow in lit/sec? If the tank is 25cm in diameter, at what rate is the liquid surface falling?
URGENT PLS
Consider the piping system shown . The average speed of water flowing through the 600-mm-diameter section of the piping system is 5 m/s. What is the volume flow rate of water in the piping system? Express the volume flow rate in L/s. For the case of steady flow of water through the piping system, what is the average speed of water in the 300-mm-diameter section of the system?
Water flows through a pipe having an inner radius of 20mm at the rate of 42 kg/hr at 20^OC. Viscosity of water is 0.001 kg/ ms. Find reynolds number of the flow?
Water at 50°F is pumped from a lake at 750 gpm through a length of 3-inch schedule 40 commercial steel pipe as shown below. The inlet to the pipe is eight feet below the surface of the lake. A 25-HP gasoline engine drives the pump and the pump has an efficiency of 80% What is the Reynolds number in the pipe? Is the flow laminar or turbulent? What is the head added to the water by the pump? What is the head loss due to pipe friction?
A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.83 mm. The nozzle shoots out water moving at 25.0 m/s. 1. Required information At what speed is the water in the hose moving? cm/s Required information What is the mass flow rate? g/s 2.
A centrifugal pump is used to pump a liquid in steady turbulent flow through a smooth pipe from one tank to another. Develop an expression for the system total head Δh in terms of the static heads on the discharge and suction sides zd and zs respectively, the gas pressures above the tanks on the discharge and suction sides pd and Ps respectively, the liquid density ρ, the liquid dynamic viscosity μ, the gravitational acceleration g, the total equivalent lengths on the discharge and suction sides (∑Le)d and (∑Le)srespectively, and the volumetric flow rate Q.
Civil engineering -Hydraulics