9. If the equation of the phase A line current is -2.15 cos (wt-25°) amp flows through a balanced star connected load each of Z = 4 +j8 Q. What is the equation of the phase C line voltage? CBA circuit.

9. If the equation of the phase A line current is -2.15 cos (wt-25°) amp flows through a balanced star connected load each of Z = 4 +j8 Q. What is the equation of the phase C line voltage? CBA circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.14MCQ: The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load...

See similar textbooks

Related questions

Q: Using the diagram below and the component photos from page 4, draw the realistic experimental setup…

A: Measuring an unknown resistance using a galvanometer or a Wheatstone bridge is a very popular…

Q: what is the scheme of the conductivity electrode

A: The conductivity electrode is a critical component in measuring the conductivity of a solution,…

Q: What is the smallest square box that will accommodate four No. 12 conductors and four No. 10…

A: Given Required box size: Square conductors in box are are 4 number of 12 AWG conductors and 4 number…

Q: Is ohm law applicable to semiconductor, insulator. Give reasons?

A: Ohm's law is a law that is associated with voltage , current and resistance. It states that the…

Q: A cylindrical 4 AWG copper wire is coated with NEMA class A insulation. The normal operating…

Q: Current in a wire with open ends. Which of the following types of current can flow through a…

A: The following question is based on the condition of current flow.

Q: Multiple Choice. Refers to a point in a circuit where three or more wires are connected. A.…

Q: The fuse as electrical circuit element - definitions, types

A: Fuse is an electrical device which is used to protect the electrical equipment from overcurrent ,…

Q: Subject name: Power System Protection

A: fusing factor and the prospective current terms related with the fuse, fuse is used for the…

Q: the aid of well labeled diagrams, explain the principle of operation of: a. a pyranometer. b. a wind…

A: A pyranometer is a scientific instrument that measures solar radiation. It is commonly used in…

Q: Mark the correct statement Select one: O a. Insulators are those materials that contain electrons…

A: The resistance of a material is directly proportional to the length of the material and inversely…

Q: Discuss the phenomenon 'treeing and tracking' in solid insulating materials under electrical stress…

A: Breakdown due to treeing: when a solid material has some impurities like gas pockets or liquid…

Q: 3- Draw the Experimental setup of the short – circuit Test.

A: The short circuit test meant for the LV side ( Low voltage side). The experimental set up can be…

Q: 4. What is PPE?

A: here we have to find the what is PPE.

Q: The resistance of a silver wire at 300C is 3 ohms. The temperature coefficient of resistance of…

A: R=Rref(1+α(T−Tref)) where, R = the resistance at temperature, T Rref = the resistance at…

Q: C.T. and P.T. are used for _________ Group of answer choices measuring high currents and voltages…

Q: What dimensions are used when measuring the area of building?See PEC 2.20.12

A: PEC 2.20.12 - according to this floor are of the building must be calculated by measuring the…

Q: Question: State the principle of reactance tube modulator?

A: It is asked to state the principle of a reactance tube modulator.

Q: Measurement

Q: Why PMMC Voltmeters can not be used to measure higher voltages directly? a. because the size of the…

Q: R, R www

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Three types of electric device A,B, and C are connected in series across a 115-volt a-c source, and…

Q: Give five examples of situations or applications where electrical circuits are used

A: Electric circuit is defined as a connectivity through which electric current flows. It is the part…

Question

100%

Subject: Electrical Circuit (EE2)

***Need asap pls. Thank you.

9. If the equation of the phase A line current is -2.15 cos (wt-25°) amp flows through a balanced star
connected load each of Z = 4 +j8 Q. What is the equation of the phase C line voltage? CBA circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
The three-phase source line-to-neutral voltages are given by Ean=100,Ebh=10+240, and Ecn=10240volts. Is the source balanced? (a) Yes (b) No
3. A three phase source, 4-wire having a per phase voltage of 230V. An unbalanced load is connected to the three phase source. The load impedances are: Zan = 15253.13° N; Zbn = 152-53.13° ; Zen = 150° Assuming negative sequence and the reference is the phase voltage "a", determine: a. the line current "a" b. the line current “b” c. the line current "c". d. the total real power e. the total reactive power f. the total apparent power g. the overall power factor h. the neutral current.
A three-phase balanced load of 15A per phase is supplied by a steel wire armoured cable with a c.s.a. of 2.5mm². The voltage drop for this cable is 15mv/A/m and the circuit is 40m long. Calculate the voltage drop in the cable.
Q4/For the three-phase power network shown in Figure. the various components are: GI: 100 MVA, 0.30 pu reactance. G2: 60 MVA, 0.18 pu reactance. Transformers (cach): 50 MVA, 0.10 pu reactance. Inductive reactor X: 0.20 pu on a base of 100 MVA. Lines (each): 80 ohms (reactive); neglect resistance. with the network initially unloaded and a line voltage of 110 kV, a symmetrical short circuit occurs at midpoint E of line 2. Calculate the short circuit MVA to be interrupted by the circuit breakers A and B at the ends of the line. T3 38 L1 L2 G2 Bas 12 T4 Bus
Power in a three phase delta system with balanced load is equal to (Sqrt (3)) (VL) (IL) (p.f.) (Sqrt (3)) (Vph) (Iph) (p.f.) (Sqrt (3)) (VL) (Iph) (p.f.) O (Sqrt (3)) (Vph) (IL) (p.f.)
Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method using an ammeter and a voltmeter? - Yes, but an instrument must be added to measure the active resistance of the load. - Yes, but an instrument must be added to measure the active power dissipated by the load. - Yes, but an instrument must be added to measure the frequency.
Q2
(b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta- connected load as shown in Figure Q2(b). Assume that it is a RYB sequence. The impedances of the load are ZrY = 50 + j50 N , ZYB = 150 + j0 N and ZBr = 50 –j50 N. jos (i) Determine and draw the phasor diagram of phase currents in the load. (ii) Determine and draw the phasor diagram of line currents in the system.
Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower 3-phase voltages. Highlight the advantages and disadvantages of each. Include the connection diagrams.
Solve it fast plz
2) A 30- resistor, a 15-0 inductive reactance, and a 12- capacitive reactance are connected in parallel across a 120-V 60-Hz line. Find (a) the phasor branch currents, (b) total current and phase angle, (c) impedance, and (d) power drawn by the circuit.