9. Calculate the energy in the 5 ohm resistor in 20 seconds. 5 ohm 10 ohm 220 V a) 21.5kJ b) 2.15kJ c) 2.15J d) 21.5J

Q: Kindly send solution. An inductance of 1 henry and a resistance of 2 ohms are connected in series…

A: The inductance,L=1 H The value of the resistor, R=2 Ω The battery voltage, VB=6e-0.0001 V

Q: In the given figure, the potential difference between points P and Q is – -

A: The solution can be achieved as follows.

Q: snown below, current I. And solve for the potential difference (a)Vaf (b) Vie (c) Vah (d) Vnf a b…

A: KVL (Kirchhoff's Voltage Law) states that the algebraic sum of all voltage in a closed loop is zero.…

Q: 1. Discuss your observations on both series and parallel circuit. (Brightness of light bulb)

A: As per the policy, I can answer only one question at a time. There are two ways of the connections…

Q: Determine the voltage with respect to ground at each point in Figure. Assume the practical model. 25…

A:

Q: The movement of electrons under the effect of electric field is directed from: Select one: O a…

A: Electrons are the negative charges.  The movement of electrons under the effect of electric field.

Q: How do I calculate this circuits values?

A:

Q: rotary standard with a KH of 1/3 when per revolution and a multiplier of 3 makes 42.4 revolutions…

A: To find the percent registration, we need to compare the expected number of revolutions to the…

Q: Determine Rin (in MQ) in the figure. 9 12 V Rp 2 kQ RG 10 M2 1 µF D IDion) = 6 mA Vas (om) = 8 V…

A: First we will find out Gain to find out input Miller resistance .

Q: 1) Calculate the current flowing through the resistor 82 (0.52A) Er Ez 4V

A: The solution is given below

Q: Load 28 VAC 2390 tums 710 turrs 350 2

A:

Q: ANSWER THE FOLLOWING AND LEAVE YOUR ANSWER IN FOUR DECIMAL PLACE

A: Given: In the given question they have mentioned a NPN transistor amplifier circuit.   Here we need…

Q: 10. If the maximum value of the current is 5√2 A, what will be the value of the average current?

A:

Q: Convert 3000 W into the equivalent Btu/hour. Show all the steps.

A: The relation between watts (W) and Btu/hour can be expressed as 1 W=3.4121 Btu/hour

Q: Which of the following arrangements of three identical incandescent bulbs DRAWS MOST CURRENT from…

A:

Q: In the circuit shown in the figure below, C₁= 4.9μF, C₂ = 8.1μF, C3= 2.4μF, and a voltage Vab= 86V…

A: Given data, C1=4.9μFC2=8.1μFC3=2.4μFVab=86V

Q: When the lights of a car are switched on, an ammeter in series with them reads 7.01 A and a…

A: According to the question, when the lights of a car are switched on, an ammeter in series with them…

Q: A moving iron voltmeter reads 250v when connected to 250v dc .if connected to 250v 50 Hz .the…

A: Moving iron instrument reads true rms value of voltage. For DC voltage, rms value is equal to dc…

Q: E h im R₁ 9.50 Ohms R₂ 19.00 Ohms Consider the LR circuit shown in the figure above: ell L=69.00 mH…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Energy can be lost to the atmosphere in the form of CO2 Heat Solar…

A: About 90 percent of energy may be lost through heat (inhalation), by movement, or by consumer…

Q: The true value of a current Is 25mA and It is indicated in a digital Ammeter as 28 mA. The absolute…

A: Given : True value, x= 25 mA Measured Value, x0=28 mA

Q: calculate the Load current and Load voltage of the given figure

A:

Q: A current 0.25 A exits in a 60-ohm lamp. The potential difference is

A: Given data, Current is given I = 0.25 A Resistance is given R = 60 ohm.

Q: How many ohms does a 14 MQ-resistor have? A) 1.4x10° 2 1.4×10° 2 B) 1.4×10° 2 1.4x10° 2 O D)

A: Given resistance = 14 M ohms.   1M = 106

Q: Refer to the Figure 2 below, what the the given voltage levels represented by letters A, and B?

A: It is given that:

Q: 50V 50V 32 20V 452 I3 B In

A:

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to a. 2.83 mA. O b. 283 mA. O…

A: In this question we need to find a maximum zener current .

Q: 30n |Oov (I 150 250

A: Determine total resistance and total current for the given circuit .

Q: When 7A current is flowing in electric circuit then the electric potential difference between B B…

A:

Q: Determine the rate at which energy is converted to heat in the 6-ohm resistor immediately after the…

A: The current/voltage through a resistor can change instantaneously in response to a change in…

Q: In figure below, The potential across the resistor is equal to: L 650 mH 120 V 60 Hz R472 :1pF

A: In parallel connection voltage is equal among all branches.

Q: Find the Vout of the circuit below during the negative half cycle. V3 c1 {I + 15 Silicon R1 V1 Vout…

A: A diode is a two-terminal one-way switch, it will only allow the flow of current in one direction,…

Q: 4. A 1-cm by 2-cm solar cell has a conversion efficiency of 9%. Determine the maximum power rating…

A:

Q: 50 ww 30 V 100 500 33 0 Rs: V P R10: V P R50: 1 V R33: 1 V ww

A: We need to find out current, voltage and power for given circuit

Q: Question 2 Determine number of electrons transferred when a current of 5mA flows a fixed point for…

A: Given data, Current, I=5 mA Time t=10 minutes

Q: Vhat is the value of "Let-go" current on human tissue at 50-60 Hz from the standard?

A: LET-GO CURRENT: The maximum value of current a person can tolerate and still be able to release…

Q: 1- 1000V to 35kV are classified under: a) Low Voltage b) Medium Voltage c) High Voltage d) Extra…

A: According to guidelines we are allowed to do only first 3 subparts. Please post again for remaining…

Q: What is the use of the tool marked in the figure? O To remove insulation layer O To cut the wire O…

A: we need to tell the use of the tool marked in the given figure.

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.