9. AU-tube manometer is connected to a pipe for measuring the pressure of oil SG=0.92 flowing in the pipeline. Mercury (SG=13.6) is used as manometer liquid and the difference of mercury level in the two limbs is 160mm. The center of pipe is 80mm below the level of mercury in the right limb. Determine the pressure in the pipeline and the head. 80 mm 160 mm

9. AU-tube manometer is connected to a pipe for measuring the pressure of oil SG=0.92 flowing in the pipeline. Mercury (SG=13.6) is used as manometer liquid and the difference of mercury level in the two limbs is 160mm. The center of pipe is 80mm below the level of mercury in the right limb. Determine the pressure in the pipeline and the head. 80 mm 160 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A3
PROBLEM 3: A venturi meter with a throat diameter of 6 cm is fitted in a horizontal pipeline of 12 cm diameter with oil of specific gravity 0.88 flowing from left to the right. The difference in level in the two limbs of a mercury manometer connected to the tapping points read 12 cm and the connecting pipes are filled with the same oil. (a) If two pressure gauges are fitted at tapping points, one at the throat and the other in the inlet. Determine the difference between the 2 gage pressure readings in kPa.
(b) A Venturi meter having a throat diameter dz of 150 mm is fitted into a pipeline which has a diameter di of 300 mm through which oil of density 900 kg/m' is flowing. The pressure difference between the entry and throat tappings is measured by a U-tube manometer, containing mercury of density 13600 kg/m', and the connections are filled with the oil. If the difference of level indicated by the mercury in the U-tube is 50 mm, calculate the theoretical volume rate of flow through the meter.
A tube with diameter of 0.3cm is inserted into water (Surface tension= 0.061N/m). The water in the tube rises to a height of 0.45cm from the surface. Calculate the contact angle between the water and the tube.
A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted piping system as shown in the figure below. The liquid in the top part of the piping system has a specific gravity of 0.8, and the remaining parts of the system are filled with water. If the pressure gage reading at point A is 60 kPa, determine (a) the pressure in the pipe at B, and (b) the pressure head, in millimeters of mercury, at point C. 3m 7m C L 3m 2m -B
The absolute pressure in a closed gas tank is 260 KPa. Compute the pressure head in meters of water.
Oil of specific gravity 0.80 is being pumped. A pressure gage located downstream of the pump reads 280 kpa. What is the pressure head in meter of oil?
Determine the pressure in psi at a depth of 5 meters below the free surface of a body of water
write your assumptions
A 200 mm long pipe slopes down at 1 in 100 and tapers from 0.25m diameter to 0.15 diameter at the lower end. If the pipe carries 100 litres of oil of specific gravity 0.85 find the pressure at the lower end. The upper end gauge reads 50 KPa.
At point A where the diameter at of the pipe is 18 cm the pressure reading is 22.5 cm of Mercury. At point B, 3 m lower than A, the diameter is 48 cm and the pressure reading is 50 cm of Mercury. If the total head loss between the two points is 1.50 m, solve for the discharge. Water is flowing through the pipe. subject: hydraulics