9 • Aluminum wires, 3 mm in diameter, a produced by extrusion. The wires the extrusion dies at an average to -ature of 350°C and at a line. orate of 10 m/min. Before lean tha 10

Q: What is the method of design called?

A: A design method is a set of various procedures that are carried out while designing planning to…

Q: In sand casting process, the pattern is made of

A: Casting is a process in which liquid metal is poured into the mould of a casting and the desired…

Q: Cad drawing and assembly drawing of a trolley jack

A: A trolley jack, also known as a floor jack or hydraulic jack, is a mechanical device used to lift…

Q: 2 cosh(lnx)

A: to find: 2cosh(lnx)

Q: For the process shown in the schematic below, which of the statements is/are incorrect? Feed hopper…

A: There are two schematic diagrams,the first diagram is the injection moldingsecond is the extrusion…

Q: Consider the simple pendulum in the figure. The pendulum is released at point A, swings through its…

A: At the highest point of its motion, kinetic energy is minimum (i.e. zero) and potential energy…

Q: at are some formulas used in GD

A: GD& T:- A symbolic language known as GD&T, or geometric dimensioning and tolerancing, is…

Q: also why is Q/T0 being subtracted in sgen1 while other 2 its being added

A:

Q: What other engine components may have to be used to be machined if the cylinder heads are machined…

A: When machining the cylinder heads on a V-type engine, several other engine components may also need…

Q: Name 3 types of fits?

A: The different types of fits are : 1) Clearance fit 2) Interference fit 3) Transition fit

Q: draw the top , left , front view?

A:

Q: Define Constant Specific Heats (Approximate Analysis)

A: In constant specific heat assumption, the specific heat is assumed to be constant at some average…

Q: What does SPC stand for?

A: SPC stands for statistical process control, which is the application of statistical instruments and…

Q: I have three parts that I need answered pertaining to the print provided below.   This print is…

A: In this drawing it is provided that the print is sheet 3 of 6 sheets.

Q: The denomination for a force or shrink fit in the US system is ?

A: Solution:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.