*8. Write the mesh equations for the networks in Fig. 17.66. De- termine the current through the resistor R,- 50. R E, = 20 VZ0( ^ E, = 40 V Z60° E, = 25 V Z lll (a) FIG. 17.66 ll

Q: Chances of fault occurrence are rare in underground cables.

A: True

Q: The one line diagram of the system and data: Gl and G2:reactance=0.2 p.u ,11kv, 100MVA T1 and T2:…

A:

Q: Explain the isolation transformer with derivative

A: We need to explain isolation transformer.

Q: Load sets are connected in series or in parallel but fuse must be always connected in a)series…

A: ANSWER:- OPTION.A

Q: In case of permanent fault, for the coordination of protective devices the following data is…

A: all of the above .

Q: Please answer. Thank you! Discuss the fault analysis in series-parallel circuits.

A: Fault analysis in a series paralleled circuits is an important aspect of electrical engineering and…

Q: transformer has double magnetic circuit.

A: Fill the blank   .........Transformer has double magnetic circuit.

Q: When a breadboard is oriented horizontally, the top positive RED rail is electrically connected to…

A: B is incorrect or false statementWhen the breadboard is oriented horizontally, the top positive red…

Q: What are the advantages and disadvantage of cascade system compared to other type of modification

A: There are 2 (or more) controllers in a cascade control system, with one controller's output driving…

Q: octal number is given by ( Note : Enter only one digit in each box. Also fill the unused boxes with…

A:

Q: 3-phase fault is the severe fault among all other faults True False

A: Choose the correct option Is it true or false The given Statment "3 phase fault is severe fault…

Q: 3) Reduce the block diagram of the system using Mason's Rule. Rist Els) 100 - ●Cl)

A:

Q: 11 To increase the voltage in the system, :the modules are connected in (ähäi 2) .Series .Parallel

A: Given, To increase the voltage of the system, the modules are connected in ____.

Q: In short circuit of single phase transformer input power is equal to

A: Short circuit test usually conducted on H.V side and L.V side is short circuited.

Q: The distribution feeder is mainly protected from the lighting, by using the process of shielding…

A: A lightning arrester is a device that protects the insulation and conductors of an electric power…

Q: A resistor can remove the direct current bias. A True B) False

A: Given :  Note : It is the kind notice that the mentioned questions are different , according to the…

Q: The time available to turn-off thyristor in load-commutated chopper is 3-2E2Cf, 4-C, 5- None of…

A: The above question is based on load commutated chopper.

Q: In a distribution system, the transient faults occurs in Both OH distribution system…

A: Choose the correct option   In a distribution system, the transient faults occurs in?

Q: The zero sequence components are with each other.

A: Zero sequence components Phase sequence?

Q: In transformer, is defined as the change in the A7 secondary terminal voltage from no-load to…

A: in transformer, ..... is defined as the change in secondary terminal voltage from no load to full…

Q: 13. The maximum primary moments in unbraced frames almost always occur at the column   (A) mid-span…

A: Ans 13 :- option B is correct. Ans 14:- option A is correct. Explanation:Question 13: Option b: This…

Q: Use of admittance

A: Use of admittanc?  Admittance Y=1/Z= I/V This is. Inverse of impedance.

Q: Which of the following is the severest and has the lowest percentage of occurrence? DLG L-L 3-Phase…

A:

Q: Duonse What will be the corresponding CT connection configuration for differential protection…

A: A current transformer is basically a transformer which steps down the main current through its…

Q: To increase the convergence of the G-S method of power flow solution the ALPHA will be None of the…

A: Need to find for convergence of GS method  value of Alpha should be

Q: $=24-260v I 40 Y & joo 江 மகன் 8-2 Is wwwx V₂ T jus www.

A: It is given that:

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: Two 36 cell PV modules are connected in series. One is shaded and the other is fully illuminated,…

A:

Q: Is the diode forward biased or reversed biased on the given circuit below? (Answer forward biased or…

A:

Q: Draw the quivalent circuit of the transformer and evaluate the different parameters using open…

A: In the question,  Draw the quivalent circuit of the transformer.  evaluate the different parameters…

Q: transformer has single magnetic circuit.

A: Given To determine which transformer has single magnetic circuit.

Q: If all the sequence voltages at the fault point in a power system are equal, then the fault is a…

A: Choose the correct☑ option If all the sequence voltage at the fault point system are equal, then…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).