8. A substation supplies power by four feeders to its consumers. Feeder no. 1 supplies six consumers whose individual daily maximum demands are 70 kW, 90 kW, 20 kW, 50 kW, 10KW and 20 kW while the maximum demand on the feeder is 200 kW. Feeder no. 2 supplies four consumers whose daily maximum demands are 60 kW, 40 kW, 70 kW and 30 kW, while the maximum demand on the feeder is 160 kW. Feeder nos. 3 and 4 have a daily maximum demand of 150 kW and 200 kW respectively while the maximum demand on the station is 600 kW. Determine the diversity factors for feeder no. 1. feeder no. 2 and for the four feeders. 1-3, 1-25, 1-183]

8. A substation supplies power by four feeders to its consumers. Feeder no. 1 supplies six consumers whose individual daily maximum demands are 70 kW, 90 kW, 20 kW, 50 kW, 10KW and 20 kW while the maximum demand on the feeder is 200 kW. Feeder no. 2 supplies four consumers whose daily maximum demands are 60 kW, 40 kW, 70 kW and 30 kW, while the maximum demand on the feeder is 160 kW. Feeder nos. 3 and 4 have a daily maximum demand of 150 kW and 200 kW respectively while the maximum demand on the station is 600 kW. Determine the diversity factors for feeder no. 1. feeder no. 2 and for the four feeders. 1-3, 1-25, 1-183]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

 A 2.4 kVA, 2400/240 V 50 Hz step downtransformer has the following parameters R1= 1.5Ω, X1= 2.5Ω, R2 = 0.02Ω, X2 =0.03Ω,Rc1 = 6kΩ, Xm1 = 8kΩ It is operating at 80% of its rated load at 0.8power factor lagging. Using the approximateequivalent circuit of the transformer referredto the secondary side, determine its efficiency, the voltage regulation andsketch its phasor diagram.
SECTION B-Choose any TWO (2) Questions from this Section Question 1 [25 Marks] (a) A commercial building has a power demand of 50 kW at a power factor of 85%. Determine (i) (ii) The annual penalty if the utility's minimum power factor is 95% and the cost of power is P10/kW/month (9) P The cost of capacitor, which when connected in parallel to the load will improve the power factor to 100%. (Assume the purchasing cost of capacitor is P30/kVAR) (10) (b) A 3-phase, 10 kVA load has a power factor of 0.342. The power is measured by two wattmeter method. Find the reading of each wattmeter. Q w Var Va = 10€ Va >= 10kVA pl: 0.36 2 (= Isine 5 3149 Question 2 [25 Marks] (a) A single-phase motor takes apparent power of 1909 VA at a power factor of 0.866 lagging when con- nected to a 230 V, 50 Hz supply. (i) Calculate current drawn from the supply (ii) (b) Draw a fully labelled equivalent circuit of a transformer Two similar capacitors are then connected in parallel with each other to form a…
how to control load voltage using hysteresys band in this buck converter 2 volt to fullfil Vload = 75v?
Range of a generating voltmeter is 30 to 300 kV dc and its indicating meterreads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of thegenerating voltmeter.
On the plate of a single-phase transformer, it is written 1800 VA, 2000/200 V, 50 Hz. In the open circuit test performed by making the transformer open circuit on the high voltage side, 200 voltmeterThe values of 0.5 A in the V. Ammeter and 18 W in the Wattmeter are read and in the short circuit test performed by short-circuiting the low voltage side, 135 V in the Voltmeter, 1 A in the Ammeter and 45 W in the Wattmeter are read. MUST WRITE ON THE CIRCUIT YOU HAVE DRAWED by drawing the approximate EQUIVALENT CIRCUIT OF THE TRANSFORMER REDUCTED ON THE HIGH VOLTAGE SIDE. Calculate your solutions and drawing legibly, and MUST WRITE LEGALLY THE results you found ON THE EQUIVALENT CIRCUIT REDUCTED TO THE L-TYPE HIGH VOLTAGE SIDE YOU DRAWN.
What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor of the plant is 60% and the plant capacity factor is 50%? 1. 15 MW 2. 10 MW 3. 20 MW 4. 6 MW
In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final answers. thank you! 2. A series-parallel ac circuit has two branches across the 60 Hz , 220 V power line. One branch has a 20 ohm R1 in series with a 10 ohm R2. The other branch has a 30 Mega ohm R3 in series with a 10 Mega ohm R4. Calculate the voltage across R4
In the circuit in (Figure 1), the load absorbs 220 VA at a lagging power factor of 0.6.
3b. I really need help with this
I need the answer as soon as possible
please answer this question 3
7. PV Modules are connected on series on order to a. Increase the system overall voltage b. Increase the system overall current c. Increase String voltage d. Both a&c e. Both b&c ||