8. A rectangular plate of mass 5 kg is suspended from four vertical wires, and a force P of magnitude 6 N is applied to corner C as shown. 300 mm 400 mm Immediately after P is applied, determine the acceleration of (a) the midpoint of edge BC, (b) corner B [Answer: adpoint of BC = 3.50k m/s', a, = 1.728i + 3.50k m/s ]

Q: What is Soil Gas?

A: Soil gases:

Q: What are the similarities and difference between the actual ASTM C143 standard and the procedure…

A: In ASTM C143, the test method includes the determination of the hydraulic cement concrete slump in…

Q: Describe about the Sliding Block Analysis.

A: The sliding block analysis method used by the Newmark is an engineering which determines permanent…

Q: What is the electrical profiling?

A: The process in which the lateral variation of resistivity in the subsurface is traced to get the…

Q: Define the term Fastener Spacing?

A: Fastener Spacing : Pitch is centre to centre spacing of the fasteners in a row, measured along the…

Q: Define metamorphic.

A: Metamorphic:

Q: How many satellites in a full GPS constellation? O 30 O 12 O24 O 18

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What is soil moisture?

A: Soil is a complex material, consists mainly of solid particles, which contains a pores or voids…

Q: A & C are incorrect, please re-work

A: As per question , I solve here only a and c. Find out - (a) Radius of curve  (c) Tangent length

Q: What is Soil stabilization?

A: Soil stabilization is a method of mixing and blending certain materials to improve the properties of…

Q: All are incorrect, can you re-work?

A: The degree of the curve = Da = 5°0' The intersection angle = 20°30' The station of the PI = 63+25.53…

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.