8. A load requires 12V and draws 3.2mA. What combination of batteries load requirements? Two parallel banks with each bank containing: A. Four 3V, 1.6mAh series-opposing connected batteries. B. Four 3V, 1.6mAh series-aiding connected batteries. C. Two 6V, 0.8mAh series-opposing connected batteries. D. Two 6V, 0.8mAh series-aiding connected batteries.

8. A load requires 12V and draws 3.2mA. What combination of batteries load requirements? Two parallel banks with each bank containing: A. Four 3V, 1.6mAh series-opposing connected batteries. B. Four 3V, 1.6mAh series-aiding connected batteries. C. Two 6V, 0.8mAh series-opposing connected batteries. D. Two 6V, 0.8mAh series-aiding connected batteries.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and internal resistance r2. Which of the following is true if we connect them in series facing the same direction? O The answer cannot be found on the other choices. O The total voltage will be 2V while the total internal resistance will be r₁ + 12. No voltage will remain while the total internal resistance will be r1 + 2. The total voltage will be V, while the total internal resistance will be r1 + 12.
Part 1 After using the UT33B multimeter to check the voltage of the batteries and the resistance of, light bulb and resistors, these are the results: - Voltage of the battery is measured to be 1608 mV, The scale used to measure voltage is 2000mV on the UT33B multimeter - Resistance of the bulb is measured to be 0.24 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor1 (R1) is measured to be 15.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter - Resistance of the resistor2 (R2) is measured to be 27.2 ohm, The scale used to measure resistance is 200 ohm on the UT33B multimeter Part 2 After connecting a circuit to find the resistance of the light bulb and resistors experimentally using a circuit, these are the results: LIGHT BULB - Resistance of the light bulb and resistors could not be measured on the UT33B multimeter, so the voltage and current were measured and the resistance was found using ohms law.…
Six Solar Panels A, B, C, D, E and F are connected as shown below. Voltages of panels A, B, C, D, E and F are 15V, 12V, 15V, 13V, 15V and 15V respectively. Currents of panels A, B, C, D, E and F are 4A, 4A, 2.5A, 4A, 2A and 4A respectively. What is the voltage(VT) and current(IT) across the output terminal of given system? +VT=? T=? Solar Panel Solar Panel Solar Panel A Solar Panel Solar Panel Solar Panel
1. Calculate the total resistance with uncertainty estimation, if the following resistors are R₁ = 10 k ± 5% and R₂ = 2.2k2 ± 10% are connected in series.
1. Calculate the total resistance with uncertainty estimation, if the following resistors are R₁ = 5.6k2 ± 5% and R₂ = 1.5k2 ± 5% are connected in series.
Complete solution and 3 decimal places.
Q2: In the Voltage Divider Cct., what is the effective of RE
Is the computed average percent error more or less than the tolerance of the resistors? Explain why.
1 Four resistors in parallel, the value of each one is 4 ohms, the current on one of them is equal to 2 amperes, find the source voltage and the voltage on each resistance, as well as the power and current on each resistance and the total capacity? 2_Four resistors in parallel, the value of each one is 4 ohms, the capacity of one of them is equal to 6W, find the source voltage and the current of each resistance?
i need the answer quickly
1) what is the effect of mismatch in series arrangement solar cells. 2)what is the effect of mismatch in parallel arrangement of solar cell. 3) which one is the worst arrangement among the all? please solve all Questions step by step