7. QIC A simple pendulum consists of a small object of mass 3.0 kg hanging at the end of a 2.0-m-long light string that is connected to a pivot point. (a) Calculate the magnitude of the torque (due to the force of gravity) about this pivot point when the string makes a 5.0° angle with the vertical. (b) Does the torque increase or decrease as the angle increases? Explain. Figure P8.6

Q: R Known values: G h TTT P R m 2600 lb 1.4 ft 1.3 slug 0.004s 8 gravity

A:

Q: The wheel is attached to the spring. The mass of the wheel is m=20 kg. The radius of the wheel is…

A:

Q: 4. An Olympic lifter (m= 103kg) is holding a lift with a mass of 350 kg. The bar exerts a purely…

A: Given the loading on the lifter and its weight.  Required: Free body diagram of the right arm.

Q: 40 cm 80 cm • A homogeneous block of weight W rests upon the incline shown in Figure. If the…

A:

Q: when two parallel springs with constants k1 and k2 support a single mass, the effective spring…

A:

Q: Q3: For the equilibrium position shown in fig. (2), 0 = 43". Find the mass (m) of the lamp fixture…

A:

Q: . A uniform ladder 10m long and weighing 350N rests against a smooth wall at an angle of 30° with…

A: W=350 NWman=700 NL=10 mx= 6m

Q: The shaft in the figure, carrying three unbalanced masses, is rotating at a constant speed hızla =…

A:

Q: . A block of mass m1 = 2.05 kg and a block of mass m2 = 6.40 kg are connected by a massless string…

A:

Q: Two blocks of mass Mi and M2 are connected by a massless string that passes over a massless pulley…

A:

Q: m M 4 m3 3) M) Im,' m2 r2 02. 03 m1 01 r4 mL m4 14

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.