7. An overexcited synchronous motor behaves like: A. Inductive load B. Resistive load C. Capacitive load D. DC generator 8. The amount of real power delivered by a synchronous generator connected to an infinite bus can be controlled by adjusting A. System frequency C. Full load frequency B. No load frequency D. Terminal voltage 9. The rotation speed of a 60 Hz, 24 pole synchronous generator is А. 1200 грm С. 300 грm В. 900 грm D. 500 грm

7. An overexcited synchronous motor behaves like: A. Inductive load B. Resistive load C. Capacitive load D. DC generator 8. The amount of real power delivered by a synchronous generator connected to an infinite bus can be controlled by adjusting A. System frequency C. Full load frequency B. No load frequency D. Terminal voltage 9. The rotation speed of a 60 Hz, 24 pole synchronous generator is А. 1200 грm С. 300 грm В. 900 грm D. 500 грm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A split-phase motor starts properly and runs but quickly overheats. What's the most likely cause of this problem? A. Bearing problemsB. Open start windingsC. Stuck centrifugal switch D. Open run windings
6- Draw the power flow diagram ion generator Does the frequency of the generated voltage depend on the rotor speed? Explain. 8- Draw the circuit diagram of the doubly fed induction generator for a wind turbine. 9- Explain how does a synchronous 10 Draw the synchronous gener nity, lag and to factor
iii) Does the Rotor of the 3 phase Synchronous Motor produce EMF, if not give the reason? And if yes mention the equation of the EMF induced.
Define the Synchronizing Torque and Damping Torque of a Synchronous Generator using the through explanations and draw the essential curves illustrating the concepts
Please answer all subparts....
Explain the operation and control of synchronous generators in a power plant.
Solve it within 30 min I will upvote
The prime mover driving SG is lost, but the machine remains connected to the large power system and the field supply also remains on. The machine will: Select one: a. get burnt b. behave as a Synchronous Generator with no change c.behave as a synchronous motor and rotate in the same direction d. behave as a synchronous motor but rotate in a reversely
A 15-kV 35-KVA 0.76-PF-lagging 50-Hz four-pole Y-connected steam-turbine generator has a synchronous reactance of 3.50 0 per phase and an armature resistance of 0.75 0 per phase. This generator is operating in parallel with a large power system (infinite bus). a) What is the magnitude of E, at rated conditions? b) What is the generator's torque angle at rated conditions? c) If the field current is constant, what is the maximum power possible out of this generator? How much reserve power or torque does this generator have at full load? d) Sketch the corresponding phasor diagram and calculate for the armature current (assume the field current is still unchanged) e) At the absolute power possible, how much reactive power will this generator be supplying or consuming?
Define the Synchronizing Torque and Damping Torque of a Synchronous Generator using the through explanations and draw the essential curves illustrating the concepts
To understand how the problems can be done in complex number format Problem 4: A 3600 rpm, 60 Hz, 13.8 kV synchronous generator has a synchronous reactance of 2002. The generator operating at rated voltage and speed with the per phase excitation voltage Eo=11.5kV and the torque angle 8-15° Calculate Stator current. Power factor. Total output power. The maximum power that can be converted from mechanical to electrical form without loss of synchronism. The value of armature current for the condition stated in (d). a) b) c) 10/19/2020 e)
Cascaded outages will cause individual generators to and results Select one: O a. make heavy losses, complete shutdown O b. heat up the windings, lose of synchronism O c. lose the synchronism, complete shutdown O d. lose the synchronism, heavy losses