cache is negligible. Available cache sis enThe smallest cache size required to ensmaverage read latency of less than 6 msin multiples of 10 MB.80706050302010o 10 20 30 40 30 0Cache s MB)The smallest cache size required la cms isMB. 17. A file system uses an in-memory cache tocache disk blocks. The miss rate of the cacheis shown in the figure. The latency to read ablock from the cache is 1 ms and to read ablock from the disk is 10 ms. Assume that thecost of checking whether a block exists in the

Answered: Image /qna-images/answer/92db0538-c23a-4721-a9ca-76660f0b12ac.jpg

7 A file system uses an in-memory cache to cache disk blocks The miss rate of the cache is shown in the figure. The latency to read a block from the cache is 1 ms and to read a block from the disk is 10 ms. Assume that the cost of checking whether a block exists in the

7 A file system uses an in-memory cache to cache disk blocks The miss rate of the cache is shown in the figure. The latency to read a block from the cache is 1 ms and to read a block from the disk is 10 ms. Assume that the cost of checking whether a block exists in the

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: What should happen if the processor submits a request that is denied in the cache while the write…

A: Introduction: The processor may refer to: (computing) The central processing unit (CPU) of a…

Q: 3) Assume that there is a cache with 4 blocks and the block size is 1 byte (in total only 4B cache).…

A: Lets see the solution in the next steps

Q: Describe two techniques that are used to keep the copy of file in the cache consistent with that in…

A: Two techniques that used to keep copy of file in cache consistent with that in main memory are…

Q: Assume a cache memory hit ratio is 93% and the hit time is one cycle, but the miss penalty is 40…

Q: Suppose a computer using direct mapped cache has 4M byte of byte-addressable main memory, and a…

A: Computer memory is a device that stores data and allows us to retrieve it when needed. Primary…

Q: A direct-mapped cache consists of 8 blocks. A byte-addressable main memory contains 4K blocks of…

A: Steps to calculate:Step 1: Calculate the cache hit rate (H) H = Number of cache hits /…

Q: 3. Suppose a computer using direct mapped cache has 2^32 byte of byte-addressable main memory and a…

A: Solution: a) It is given that the size of the main memory= 232 bytes Cache size = 1024 bytes = 210…

Q: Question (la) A cache system is to be designed to store data from a 256 MB memory space. If each…

A: The solution for the above questions are:

Q: The following blocks are referenced by the CPU and to be fetched from the RAM to the cache…

A: The following blocks are referenced by the CPU and to be fetched from the RAM to the cache…

Q: Computer Science Consider a direct-mapped cache with 8 lines, each holding 16 bytes of data.…

A: a) We must utilize the provided cache and memory sizes to calculate the number of bits for the tag,…

Q: What is the biggest size we can have for a file with SFS? (b)Provide data block numbers in sequence…

A: SFS ( Answering only for the first part) The Smart File System (SFS) is a journaling filesystem…

Q: Question#4: Consider a file system that uses inodes to represent files. Disk blocks are 8 KB in…

A: answer is

Q: list of 32-bit memory address references, given as words: 3, 180, 43, 2, 191, 88, 190, 14, 181, 44,…

A: In computing, a cache is a high-speed data storage layer which stores a subset of data, typically…

Q: If a cache request comes in while a block is being written back into main memory from the write…

A: The write buffer and the cache operate separately. The request may be handled by the cache as if the…

Q: A cache is set up with a block size of 32 words. There are 64 blocks in cache and set up to be 4-way…

A: Each block has 32 words, so the block offset = 25 words. So Block offset field can be represented by…

Q: Move a block of N consecutive bytes of data starting at offset address BIK1ADDR in memory to another…

Q: 1. Suppose a computer has 2³2 bytes of byte-addressable main memory and a cache size of 2¹5 bytes,…

A: a) The total number of bytes of main memory is 232 bytes. Since each memory block contains 64 bytes,…

Q: If the requested data is too large to fit in the cache, a write buffer will transmit it back to the…

A: In modern computer architecture, the cache is an essential part of storing frequently used data to…

Q: When a block is being returned from the write buffer to main memory, what should the CPU do if a…

A: *) When a CPU performs a write operation, it typically writes the data to a write buffer or a store…

Q: Suppose that we have a computer that uses a memory address of 12-bits. This computer has a 64-byte…

A: Suppose that we have a computer that uses a memory address of 12-bits. This computer has a 64-byte…

Q: A computer using a direct mapped cache has 220 Bytes of memory (byte addressable) and a cache of 32…

A: Given that a direct mapped cache has 220 Bytes of memorycache of 32 blocks, and each block contains…

Q: What should the CPU do when a cache request arrives while a block is being flushed back to main…

A: When a processor wants to read or write data from memory, it typically first checks its cache to see…

Q: Problem 0. The following table gives some of the parameters for a number of different hardware…

A: Hardware caches play a critical role in improving the performance and efficiency of modern computing…

Q: Accesses between various levels of the memory hierarchy are made faster by using buffers. In this…

A: Step 1 Introduction: Buffer A designated province of memory within the program for storing the…

Q: 27. Why are the tag bits of a memory address important in a cache memory system? A. The more tag…

A: The tags of all cache lines in the specified set are compared to the tag bits. A cache hit occurs…

Q: Q4: With the reference of a suppose 93% of the memory accesses found in cache then what is average…

Q: If the CPU receives a cache request while returning a block from the write buffer to main memory,…

A: The question is asking what action the Central Processing Unit (CPU) should take if it receives a…

Q: Ox21 Oxe0 Ox05 0x31 Oxdb Ox30 0x3f Ox81 Oxf9 Oxa1 Ox56 Ox05 Ox84 Ox68 Oxf9 Ox78 Oxbd Oxa9 0x8c Oxc2…

A: Here from question Memory address of it = 0x964 = 1001 0110 0100 (binary equivalent) 12-bit length…

Q: quentially: (i j k L L j m j n L m j m L k S j P i O…

A: it will take 3 bits for counter as 23=8 to apply LRU algorithm. 2 . Now check the answer to check…

Q: Suppose a computer using direct-mapped cache has 2 bytes of byte-addressable main memory and a cache…

A: Given: The computer is using direct-mapped cache. Size of the main memory = 220 bytes Size of the…

Q: Suppose a byte-addressable computer using set-associative cache has 216 bytes of main memory and a…

A: Introduction of Cache Mapping and its types: A cache is very high-speed computer memory and it is…

Q: Assume that disk reads are managed using a buffer pool. The buffer pool contains five buffers and…

Q: 13. T F In a mirrored array, each disk stores exactly the same data. 14. T F Write back in cache…

A: Q 13. True

Q: Q2) The typical access time for a hard-disk is 10ms. The CPU is running at a 100MHz clock rate. How…

A: In 1 second the cpu runs 108 cycles. Therefore, in 10-2 seconds the cpu would run 10-2 x 108 = 106…

Q: The following blocks are referenced by the CPU and to be fetched from the RAM to the cache…

A: Dear Student, You have not provided the set associativity so I am assuming it to be 8-blocks per set…

Q: Each inode in a file system has 5 direct pointers to disk blocks, 3 single-indirect pointers to disk…

A: Given:

Q: 5. suppose a computer using fully associative cache has 224 bytes of byte-addressable main memory…

A: Given: 5. suppose a computer using fully associative cache has 224 bytes of byte-addressable main…

Q: And answer the following questions: Question12: Which disk schedualing algorithm is most…

A: In this question we have given some disk scheduling algorithm name..and asked which algorithm is…

Q: List the two main principles used in the design of memory hierarchies and explain them briefly.…

A: A)List the two main principles used in the design of memory hierarchies and explain them briefly.…

Q: There are many parameters that could be used to describe disk performance; among them are: number…

A: Many parameters can be used to describe disc performance, including: number of bits per track…

Concept explainers

Types of database architectures

A Database Architecture represents the Database Management System’s (DBMS) design (schema). The DBMS architecture makes it easy to understand the components involved in the database system and their relations. The DBMS architecture may vary based on the system on which it runs. Some systems contain both client and server machines whereas some run only on a server machine. Based on the architecture, the system can be classified as centralized, decentralized, or hierarchical.

Question

cache is negligible. Available cache sis en
The smallest cache size required to ensm
average read latency of less than 6 ms
in multiples of 10 MB.
80
70
60
50
30
20
10
o 10 20 30 40 30 0
Cache s MB)
The smallest cache size required la c
ms is
MB.

17. A file system uses an in-memory cache to
cache disk blocks. The miss rate of the cache
is shown in the figure. The latency to read a
block from the cache is 1 ms and to read a
block from the disk is 10 ms. Assume that the
cost of checking whether a block exists in the

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

What should happen if the processor issues a request during block writing from the write buffer to main memory and the request is satisfied by the cache?
A virtual memory has a page size of 16 words. There are 8 pages and 4 blocks. The associative memory page table contains the following entries. (Addresses are given HEX form): Page Block a) For the following virtual addresses find the CPU addresses: 3A, 5B, 1 3 b) For the following CPU addresses find the virtual addresses: 0C, 2D 1 4
. Cache Write Policies In a cache system using a write-back policy, if a cache block is modified and marked as "dirty" but not yet updated in the main memory, and that block is selected for replacement, what action should be taken to ensure data integrity?
There are many parameters that could be used to describe disk performance; among them are: number of bits per track disk capacity (in bits) number of disk surfaces rotational speed rotational latency transfer rate tracks per surface sectors per track blocks per track sectors per block seek time speed of disk arm block-read time number of blocks Some of these parameters are independent, and others are (approximately) linearly related. That is, doubling one doubles the other. Decide which of these parameters are linearly related. Then, select from the list below, the relationship that is true, to within a close approximation. Note: none of the statements may be true exactly, but one will always be much closer to the truth than the other three. Also note: you should assume all dimensions and parameters of the disk are unchanged except for the ones mentioned. a) If you double the number of sectors per block, then you double the number of blocks on the disk. b)…
A 2-way set associative cache consists of four sets. Main memory contains 2K blocks of eight words each. Show the main memory address format that allows us to map addresses from main memory to cache. Be sure to include the fields as well as their sizes. Compute the hit ratio for a program that loops 6 times from locations 8 to 51 in main memory. You may leave the hit ratio in terms of a fraction. Please show details how you obtain the result.
Suppose a computer using direct-mapped cache has 232 bytes of byte-addressable main memory and a cache size of 512 bytes, and each cache block contains 64 bytes.Q.) How many blocks of main memory are there?
A computer of 32 bits has a cache memory of 64 KB with a cache line size of 64 bytes. The cache access time is 20 ns, and the miss penalty is 120 ns. The cache is 2-way associative. a) What is the number of cache lines? b) What is the number of cache sets? c) What is the number of lines per set? d) Draw a scheme of this cache. e) Calculate the time to read a word in case of miss.
A computer is using a fully associative cache and has 216 bytes of main memory (byte addressable) and a cache of 64 blocks, where each block contains 32 bytes. a. How many blocks of main memory are there? b. What will be the sizes of the tag, index, and byte offset fields? c. To which cache set will the memory address 0xF8C9(hexadecimal) map?
What should happen if the processor provides a request that is not satisfied in the cache while a block is being transferred back to main memory from the write buffer?
Performance: *(15 min.] Your computer has a cache that is utilized 40% of the time. You would like to improve the performance of the cache to improve the overall performance of your computer. How fast your cache should be to achieve 1.5 times better overall processor performance? Do not write just numbers. Show your work.
Cache Mapping a. A computer system has a main memory with 128 blocks and a cache with 32 blocks. If it uses direct mapping, how many main memory blocks can be mapped to a single cache block? b. In a set-associative cache with 64 blocks and divided into 4 sets, determine the associativity of each set. c. For a fully associative cache with 256 blocks, how many sets are there?
Q: A set-associative cache has a block size of 256 bytes and a set size of 2. The cache can accommodate 32 KB. . The size of main memory is 256 KB. Design the cache structure and show how the processor’s addresses are interpreted. Note: this question is related from coal subject.