7-123 A refrigeration unit compresses saturated R-134a vapor at 10°C to 1000 kPa. How much power is required to compress 0.9 kg/s of R-134a with a compressor efficiency of 85 percent? Answer: 19.3 kW

Q: 1 mol of N2 gas in a volume of 300K and 2L undergoes an isothermal reversible expansion up to 20L…

A:

Q: An ideal gas with Cpm= 30.0 JK 'mol¹ and Cvm=20.7 JK 'mol is expanded from 500 K, 5 atm to a final…

A: Given, Temperature, T=500K Initial temperature, P1=1atm Final temperature, P2=5atm a. The work done…

Q: An insulated piston-cylinder device contains 0.05 m³ of saturated frigerant-134a at 32°C. The…

A:

Q: 0.04 m3 of gas at a pressure of 1482 KN/m2 is expanded isothermally unit volume is 0.09 m3,…

A: Given : Initial volume (Vi) = 0.04 m3 Pressure (P) = 1482 kN/m2 = 1482 x 103 N/m2 Final volume (Vf)…

Q: F d T

A:

Q: espectively. The final préšsurė

A:

Q: A monatomic ideal gas initially fills a V0 = 0.35 m3 container at P0 = 75 kPa. The gas undergoes an…

A:

Q: Sketch a PV diagram and find the work done by the gas during the following stages. (a) A gas is…

A: The work is the scalar multiplication of force and change in certain environmental conditions. For…

Q: A monatomic ideal gas initially fills a V0 = 0.45 m3 container at P0 = 85 kPa. The gas undergoes an…

A: Heat absorbed Q3=-W3=-nRT0lnVfVi=-nRP0V0nRlnV1V0=-P0V0lnV1V0

Q: A gas undergoes an expansion process in which its volume increases from 1.5 m³ to 4.5 m³ at a…

A: We have a gas that expands at a constant pressure, which is known as isobaric process.Initial volume…

Q: The volume of 1 mol of an ideal gas initially at 2 atm, 25 oC and 12.2 L volume is doubled by an…

A:

Q: An ideal monatomic gas increases in pressure from 149 kPa to 242 kPa at a constant volume of 2.2 m³.…

A: Formula to calculate the energy transferred by heat during the process: Q = ΔU + W where Q is the…

Q: Air (ρ = 1.26 kg/m3 ) enters a compressor at a rate of 8.50 m3 /min and a pressure of 101.325 kPa,…

A: Given, ρ = 1.26 kg/m3 compressor at a rate of 8.50 m3 /min  pressure 618 kPa

Q: 1.00 mole of an ideal gas occupying 2.00 L is maintained at a constant temperature. An external…

A: Given: The initial volume is 2 L. The final volume of the gas is 0.1 L. The external pressure is 6…

Q: To pump air into a tank, measured at 5.92 x 10 Pa gauge pressure, a cylindrical air pump with a…

A:

Q: Find the work done when 1 mole of a gas that has the equation of state PV=RT+APT-BP expands in an…

A: Given data:- The given equation of state is, PV=RT+APT-BP

Q: The internal energy of a monatomic ideal gas is 1·5 nRT. One mole of helium is kept in a cylinder of…

A:

Q: Q20. An ideal gas is compressed adiabatically from an initial volume V to a final volur and a work W…

A:

Q: A fluid with a pressure of 820 kPa, specific volume of 0.30 m/kg and a velocity of 150 m/s enters a…

A: Concept: To Determine the change in internal Energy we will use equation of Steady flow of Energy.…

Q: a) The mass flow rate of air through the turbine b) The diameter of the turbine exit pipe in (cm)…

A: Given: Air enters steadily a turbine at 2 MPa and 400 Degree C  Velocity=200 m/s exists at 100kPa…

Q: An ideal gas expands against a constant external pressure of 2.0 atm from 20 L to 40 L and absorbs…

A:

Q: how much work is required to compress 15.00 mol of air at 20.0 degrees celsius and 1.00 atm to 1/10…

A: number of moles = 15original temperature = 20C = 293 K original pressure = 1 atm original volume = V…

Q: One mole of an ideal gas is kept in a container at an initial pressure of 2 kPa and temperature . It…

A: The first law of thermodynamics is just energy conservation law for thermodynamical process. It says…

Q: A fluid at 0.7 bar occupying 0.06 m³ is compressed reversibly to a pressure of 9.7 bar and specific…

A: Given: P1=0.7barP2=9.7barP3=1.3barV1=0.06m3V2=V3v=0.5m3/kg

Q: piston performed 0.48 kJ of work on 0.5 mol of oxygen gas in a cylinder during an isothermal…

A:

Q: You are to expand a gas adiabatically from 3 MPa and 300C to 80 kPa in a piston–cylinder device.…

A: It is given that,

Q: The PV diagram shows three moles of an ideal monatomic gas going through a cyclic process. The…

A: The parameters given in the question are as follows: Cv=32R, Cp=52R Pressure at A=Pressure at…

Q: An ideal diatomic gas with gamma = 1.4 is compressed adiabatically so that its final pressure is…

A: The objective of the question is to find the final volume of an ideal diatomic gas that is…

Q: A 2.50-mol sample of gas is compressed isothermally from 20.0L to 5.00L under a constant external…

A: Given , No. Of mole of gas (n)= 2.50 mol  Initial volume ( Vi) = 20L  Final volume (Vf) = 5L…

Q: In an adiabatic expansion of an ideal gas, a work of 125 J is done  . What is the internal energy of…

A: adiabatic expansion-                                 In the adiabatic process, there is no heat…

Q: 7. Calculate the net work of the cycle

A: Net work of the cycle:The net work of the cycle is the sum of the work done in each process. The…

Q: Check my work mode: This shows what is correct or incorrect for the work you have completed so far.…

A: The PV diagram shown is for a heat engine that uses 1.170 mol of a diatomic ideal gas as its working…

Q: Air enters an adiabatic nozzle at 60 psia, 5408F, and 200 ft/s and exits at 12 psia. Assuming air to…

A:

Q: An ideal gas initially at 300 K undergoes an isobaric expansion at 2.50 kPa. If the volume increases…

A:

Q: A diesel engine works at a high compression ratio to compress air until it reaches a temperature…

A:

Q: 4.00l sample of a diatomic ideal gas with specific heat ratio 1.40 confined to a cylinder is carried…

A: Given: The initial volume is V=4 L. The specific heat ratio is γ=1.4. The pressure is P'=1 atm. The…

Q: An adiabatic rigid steam tank has expansion valve. Initially, steam is at 5MPa and 600oC. Suddenly,…

A:

Q: Refrigerant 134a expands in a piston-cylinder assembly from p; a 200 lb/in? and T₁-140°F to p2-30…

A:

Q: An ideal gas is compressed adiabatically from an initial volume V to a final volume aV and a work W…

A: