67. In a short circuit test on a circuit breaker, the following readings were obtained on single frequency transient : Time to reach the peak restriking voltage = 50 μ sec Peak restriking voltage = 100 kV The average RRRV is (1) 2× 106 kV/sec (ii) 4 × 106 kV/sec (iii) 5.6 × 106 kV/sec (iv) none of above

67. In a short circuit test on a circuit breaker, the following readings were obtained on single frequency transient : Time to reach the peak restriking voltage = 50 μ sec Peak restriking voltage = 100 kV The average RRRV is (1) 2× 106 kV/sec (ii) 4 × 106 kV/sec (iii) 5.6 × 106 kV/sec (iv) none of above

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a three phase (50Hz) full converter, the ripple frequency in output voltage?
For half wave rectifier circuit shown below Is = 5sin(wt), ripple factor = Is R. O a. 2,5 Ob. 1.21 О с. 1 o d. 2.1
Quiq
A single phase full wave ac/ac converter's input voltage is Vs (rms)= 220 Volt. The firing delay angles are a1= n/2 and a2=3 n/2 respectively Which one is the rms value of the output voltage ?
In single phase fully controlled converter, if the form factor is 4.75 then the ripple factor of the converter is
Don't use ai to answer I will report your answer .. Solve it Asap with explanation and calculation
Determine the RMS Noise Voltage when the noise readings measured at several times has these values: 25mV= 2 times, -22mV = 3 times, 10mV and - 72mV = 8 times.
Please solve the marked question.
so then how is Rth 0.8695 kOhms in the original explanation?
Q1888
Please determine based off waveform A)peak amplitude B)peak to peak value C)average value
a. A circuit with half-wave rectified signal has a dc voltage of 0.318Vm. The rms value of the ac component of the output signal is 0.385Vm. Calculate the percentage ripple of a half-wave rectified signal.