6/5 The 1.2-kg wooden block is used for level support of the 9-kg can of paint. Determine the magnitude and direction of (a) the friction force exerted by the roof surface on the wooden block and (b) the total force exerted by the roof surface on the wooden block. Ans. (a) F 31.6 N, (b) P 100.1 N up %3D PAINT H=0.90 4. 12

Q: Solve for x.       x + 1   0 −1   x    = 2

A:

Q: Add the vectors using triangle rule or parallelogram rule

A: Draw the diagram of the vector system.

Q: 2 Constraint indicated the name and where it should be

A: Given: To find: Where the constraint should be

Q: solve by showing every step.

A: Given data: The ultimate tensile strength of component is Sut = 30 ksi. The ultimate compression…

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: Identify the following sectioning views (a, b, and c). a O Removed, Revolved and Removed O All…

A:

Q: Question 24 In the same setup as in question 23, if the mass of the crane arm (including winch) is…

A: Solution for Question 24: Given, Mass of arm = m = 100 kgWeight of arm = W = mg = (100) (9.81) = 981…

Q: 1500# 1500# 1500# 1500# 12' K I

A: In this problem, following steps will be taken 1. Determine the reactions at the supports.' 2. Using…

Q: Calculate y, the distance from the base to the position of the Neutral Axis of the T-section shown…

A:

Q: solve a thru e show all steps

A: is normal reaction force between contacting surfaces.W is the weight force of the block. is the…

Q: What is Line G?

A: Solution:

Q: Solve the triangle AABC a = 10ft , %3D A = 35°, B = 25° %3D Angle C = type your answer... degrees,…

A: Given : The length of side a = 10 ft Solution: The sum of the angles of a triangle is 180° Thus ,…

Q: 2. The size of 1/2 in. would refer to the with regard to ACR copper tubing.

A: The correct option is (b)  Outer Diameter (OD)

Q: A hollow tube with thickness t = 1/4 in. is applied with a tensile load of 33 kips. Compute its…

A: Given data,  Tensile load P= 33kips = 33000 lbs  t= 1/4 in  Tensile stress S= 12 ksi = 12000 lb/in²…

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.