64 kN 120 kN/m PROBLEM 9.135 dp I For the beam and loading shown, determine (a) the slope at point C, (b) the deflection at point D. Use E = 200 GPa. W310 x 44.5 1.8 m -1.8 m- 12 m 1=99.2×10“m*

Q: Use moment area method to determine the slopes and deflections at points asked? 2-a) find deflection…

A: Given Data Determine the slope and deflection at point B and C using moment area method.

Q: Compute the vertical and horizontal deflections of B by the virtual work method. Given E=200GPa and…

A: Given:- E=200 GPaI=108 mm4 To find:- Vertical and horizontal deflection of B Concept:- Virtual work…

Q: lease answer will durely given an upvote

A: In conjugate beam method, real beam is converted to conjugate beam by changing support condition of…

Q: Using Virtual Work Method Find the smallest value of P acting at the FD midspan that is required in…

A: To determine:Minimum Force P for zero deflection at B using Virtual work method

Q: Using Virtual work method on Determinate frames, determine the horizontal deflection and slope at…

A: ###Calculation of horizontal deflection and Slope At C using virtual work method of analysis

Q: Describe the  procedure that  provides a method that may be used toapply the two moment-area…

A: Moment Area Method (Mohr’s Method)

Q: How would you graph this on V (shear) linear graph and moment graph parabolic?

A:

Q: Problem 1: Use area-moment method and double integration method to determine the slope and…

A: EI = ConstantDetermine the slope and deflection at the point B using Area-Moment method and Dobule…

Q: Problem 7: Determine the angle 0 between the y axis of the pole and the wire AB. 3 ft 2 ft 2 ft 2 ft

A: Given :- To find :- Angle between y axis of the pole and wire AB

Q: CALCULATION PROBLEM 1. For the beam shown use VIRTUAL WORK METHOD to determine the value of the…

A: Solution_1

Q: Describe the moment area method for determining the deflection in beams

A:

Q: Determine the smallest cross-sectional area, (A) required for the members of the truss shown below,…

A: The solution is in step 2:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.