6.36 Given the network in Fig. P6.36, find (a) the power dissi- pated in the 3-2 resistor and (b) the cnergy stored in the сараcitor. 2H 3H 15 V 6A 2F Figure P6.36

Q: 19. Which of the following is a universally adopted shape of cell?

A: The correct option along with the explanation is provided in the following section.

Q: Calculate the energy range between two energy levels E₁ and E2. Probability of finding electron in…

A:

Q: By doing the " Coloumbs Law Lab " how do you calculate the electric force on suspended balloon and…

A:

Q: What is the expression of thermal voltage? Find out the value of the thermal voltage at 300 K.

A:

Q: An electron is ....... than a proton. A. LighterB. Heavier

A: The nucleus of an atom is made up of protons and neutrons, whereas the electrons are present outside…

Q: A rubber rod is rubbed with fur, so that the fur becomes positive. The rod is then used to charge an…

A: When a rubber rod is rubbed with fur, it becomes positive because electrons are transferred from fur…

Q: What is the mathematical definition of Kw?

A:

Q: What is a proton? Where does it normally exist in an atom, and what is its charge?

A: Proton

Q: An electron is ....... than a proton.  A. Lighter B. Heavier

A: Electron is a negative charge particle.   Proton is A positively charged particle   THE MASS OF…

Q: Define ripple voltage and discuss the way to reduce the magnitude of the ripple voltage

A: Ripple voltages Ripple voltages are the ones not having a constant magnitude, There will be…

Q: What equations are Resistive Force

A: The resistive force acting on a body moving with velocity v through a fluid at rest is given by:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.