6.00 2 ww 25.0 N 8.00 2 ww- 20.0 2 In the circuit shown above the battery has negligible internal resistance. The current through the 8.00 Q resistor is 4.00 A. What is the emf of the battery? Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: x10 Answer units

Q: Convert 200 25 mi/hr to yards/sec (use 1m=1 094yards) Express your answer in 2 decimal places Answer…

A:

Q: In the figure the ideal batteries have emfs 8₁-22.7 V, 82-10.1 V, 83-5.26 V, and 84-5.28 V, and the…

A: When a question with multiple subparts is given then, according to the guidelines, only the first…

Q: Name the physical quantity which is measured using meter scale ?

A: Meter scale is a device usee to measure length.

Q: One micrometer means  1/ 10 _6 of a meter 1/103  of a meter 1/10+ 6 of a meter No answer text…

A: Required: 1 micrometer in terms of meter

Q: how is 0.992 the radius?

A: The radius value is already mentioned in the question.

Q: b) Calculate the energy delivered to the ment at t 10, 30, and 80 ms. %3D

A: (b) part of this problem is solved. Given: The figures given is as follows:   Introduction: Power…

Q: The equation of a transverse wave on a string is y = (4.9 mm) sin[(17 m²1)x+ (650 s 4)t] The tension…

A: The equation of a transverse wave on a string is : y = (4.9 mm) Sin[ (17 m-1)x + (650s-1)t]Tension…

Q: object measured by a __________ in grams and does not change…it stays the _________

A: The gram and kilogram are two units used to measure mass in the metric system.The basic SI unit of…

Q: In the figure shown below the ratio "sin 03/sin 0," 03 02

A:

Q: hat is the actual reading of the device in centimeters?

A: Given:- The image of the vernier caliper Find:- Find the reading shown by the vernier caliper

Q: In the figure here, a ball is thrown up onto a roof, landing 4.80 s later at height h = 21.0 m above…

A: When the object is thrown with some initial velocity at an angle from the surface the motion is…

Q: Define the following term: SI units

A: The SI unit is also called an international system of units and they are used universally as a…

Q: What is the correct way of writing si unit

A: It should be written in

Q: maximum error percentagee

A: This question is based on calculation of error .   As i can see  , values in  the options are…

Q: How can magnitude be calculated in a physics problem?

A:

Q: can you check your answer for the last problem because I am getting 1.07

A:

Q: 48. You are working with the formula V = ²h. You are given values of r= 1.00 ft and h = 2.00 ft.…

A: Detailed solution of given question is given in below steps.

Q: The error in two readings of A are 0.01 and -0.03, then mean absolute error is ?

A: The error in two readings of A are 0.01 and -0.03 First, the absolute value of the errors is taken…

Q: A football field is 100. yd long. Convert this distance to Sl units.

A: The objective of the question is to convert the length of a football field from yards to meters,…

Q: The figure shows a cycle undergone by 1.50 mol of an ideal monatomic gas. For 1 to 2, what are (a)…

A:

Q: How to measure the seconds?

A: Historically, definition of second was based on the division of the Earth’s rotation cycle. Second…

Q: bottom of the what distance

A: GivenA cylindrical tank filled with water to depth, D=0.35 mCrossectional area of hole, A=6.67…

Q: Solve the inequality, and express the solutions in terms of intervals whenever possible

A: Given: To find the speed with the values as, M=-130v2 +52v, 0<v<70

Q: Find the dimensions of the quantity in the equation, h An 2n/ 2m(Uo - En) : O L O L·T O L·M/T2 O M O…

A: ∧n = h2π2m(Uo-En)where h is the planck's constant Uo and En are the energies m is the mass

Q: In an experiment on standing waves, a string 78 cm long is attached to the prong of an electrically…

A:

Q: Which UNIT will the answer to this operation have? (We're only interested in the units, not the…

A: Given data:  5 m.s2 s2 Required: The unit of the given operation

Q: Determine the values of /, and I, that satisfy the following two equations. 9.25 + 3.30/, - 2.35/2 =…

A:

Q: Convert minutes to units in 10-minute increments.

A: To convert minutes into units ,      1 hours = 60 minutes . this implies ,                 1 min…

Q: Explain the difference between the measurable units and derived units with suitable examples.

A: Unit: The word unit which can be define the right position in a number or the one’s place is known…

Q: (a) The volume V of a growing spherical cell is V = ³, where the radius is measured in micrometers…

A: According to question we need to find--- (a)  Find the average rate of change of V with respect to…

Q: digit(s) after the decimal point. When 15.9 is added to 99.6, the result should be reported with…

A: The problem ks based on tbe concept of significant figues and basic concept of rounding off. The…

Q: why did you do times 3.2?

A:

Q: Which of these numbers are NOT in scientific notation? O 2.0 x 100 O 10 x 102 O 1.2 x 103 O5.3 x 109

A: Scientific notation of a number: The proper format for scientific notation is a x 10^b where a is a…

Q: Convert the following to Sl units: 38 Jam/ms

A: SI unit or International System of Units is the modern form of metric system that is used around the…

Q: Solve the following operation(s) and express final answers to the correct number of significant…

A: We have to solve the following operations and express final answers to the correct number of…

Q: D = m/V for V (density = mass divided by volume)

A: Density is defined as the mass per unit volume. Its unit is g/mL or g/cm3.

Q: I got an question, why is the 1.22 negative

A: Here given gravitational potential energy= -mgh

Q: 1 = = I cos (wt + p ・I cos (wt - p 1₂ (1

A: I1= - I cos(ωt+φ) I2= - I cos(ωt-φ) solution for I1 + I2 can be solved using the identity:…

Q: Perform the following operation leaving your answer with the correct number of significant figures:…

A:

Q: Convert 3.7 from g/m³ to SI units. Answer units

A: Given To convert 3.7 g/m3 to SI unit.

Q: &= 25 V & = 36V R-140 R-40 R-70 R-40 I=7A &= 20V F A)" T

A:

Q: Find the least count of a milliammeter in which there are 20 divisions between 400mA and 500mA.

A: The Least count = range/no.of divisions No. of divisions = 20