6. [] You have collected a tissue specimen that you would like to preserve by freeze drying (Dr. Cahill does this!!) To ensure the integrity of the specimen, the temperature should not exceed -5.00°C. The vapour pressure of ice at 273.16 K is 624 Pa. What is the maximum pressure at which the freeze drying can be carried out? AH fuzion=6010 J mol-¹ and 4Hvaporization=40656 J mol-¹

6. [] You have collected a tissue specimen that you would like to preserve by freeze drying (Dr. Cahill does this!!) To ensure the integrity of the specimen, the temperature should not exceed -5.00°C. The vapour pressure of ice at 273.16 K is 624 Pa. What is the maximum pressure at which the freeze drying can be carried out? AH fuzion=6010 J mol-¹ and 4Hvaporization=40656 J mol-¹

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Acetone has a vapour pressure of 53.3 kPa at 39.5 °C and 202.6 kPa at 78.6 °C. From the above data, obtain an equation to correlate the vapour pressure of acetone. (The equation should be in the form In(P)= -A/T + Co where P, is in kPa units. Find numerical values for A and Co) A= 5756 K, Co = 17.989 A= 4756 K, Co = 16.989 A= 3756 K, Co = 15.989 A= 2756 K, Co = 14.989
On a single-component phase diagram, one must cross a coexistence line to move from the region for liquids to the region for gases. True False
A saturated solution of copper(ll) sulfate, with excess of the solid, is present in equilibrium with its vapour in a closed vessel. (a) How many phases and components are present? (b) How many degrees of freedom are available, and what are they?
What mass of H2 gas can be collected over water from a 250-mL flask at a temperature of 25ºC and a pressure of 105.325 kPa? (The vapour pressure of H2O at these conditions is 3.169 kPa.)
In this lab, you will start off by calculating the number of moles of air molecules inside a flask containing 20 mL of water by cooling the flask down to near 0°C and assuming the vapour pressure of water is negligible at that temperature. If the volume of the air inside the flask is 145.2 mL, the gas pressure sensors reads 101.3 kPa and the temperature sensor reads 3.7 °C, how many moles of air are present in the flask? Express your answer in mol. Assume R = 8.314 J mol-¹ K-¹. Answer:
A solution containing 30 g of non-volatile solute exactly in 90 g of water has a vapour pressure of 2.8 kPa at 298 K. Further 18 g of water is added to this solution. The new vapour pressure becomes 2.9 kPa at 298 K. Calculate:(i) the molecular mass of solute and(ii) vapour pressure of water at 298 K.
(a) Identify the major phases (ice, water, vapor) on the unary phase diagram of H2O below.
Answer Q10, 11, 12
SHOW COMPLETE SOLUTION AND WRITE LEGIBLY The molar volume of a certain solid is 142.0 cm3 mol-1 at 1.00 atm and 427.15 K, its melting temperature. The molar volume of the liquid at this temperature and pressure is 152.6 cm3 mol-1 . At 1.2 MPa the melting temperature changes to 429.26 K. Calculate the enthalpy and entropy of fusion of the solid.
A solvent (molar mass = 98.2 g mol-¹) has a vapour pressure of 4930 Pa at 20 °C; at 50 °C this increases to 1.94 x 104 Pa. A mass of 12.8 g of an unknown solute is dissolved in 100.0 g of the solvent. Assume the solute has negligible vapour pressure. Estimate the normal boiling point of the solution.
At 413K the vapor pressure of pure chlorobenzene is 1.237 bar and that of pure bromobenzene is 0.658 bar. These solvents form ideal solutions. A) What is the mole fraction of chlorobenzene in a mixture of these two that just boils at 413K at 1 bar? b) What is the mole fraction of chlorobenzene in the vapor produced in (a)? c) Supposed this vapor is condensed what is its total vapor pressure at 413K?
The liquid-vapour equilibrium diagram of the acetone-chloroform mixture is shown below. A mixture containing 40% (molar percentage) of chloroform was heated to a temperature of 60°C, under a pressure of 1 atm. a) For a temperature of 60°C, what is the molar fraction of chloroform in the liquid phase and what is the molar fraction in the vapor phase, respectively?b) What is the molar fraction of chloroform and acetone at the azeotropic point?