Answered: 6. The resistivity of aluminum is 2.8 x… | bartleby

Related questions

Question

6. The resistivity of aluminum is 2.8 x 106 02-cm. If an aluminum resistor is a wire of
length 50cm and has cross sectional area of 2.2 x 106 cm2, find the resistance of
the wire.

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

How long L is a tungsten wire if it has a diameter of 0.199 × 10-³ m and a resistance of 3.85 kQ? The resistivity of tungsten is 5.62 × 10-8 22.m.
1. Gold wire (resistivity p=2.44 x 108 Qm) with a diameter of 2.0 mm is being unwound and a certain length is selected. (a) What should be the length if we want the selected wire to have a resistance of .10 Q? (b) If I put the wire across a potential difference of 30 V, how much energy is dissipated as heat in an hour?
18. A certain lightbulb has a tungsten filament with a resistance of 19.0 Q when at 20.0°C and 140 N when hot. Assume the resistivity of tungsten varies linearly with temperature even over the large temperature range involved here. Find the temperature of the hot filament.
How long is a tungsten wire if it has a diameter of 0.195 x 10 m and a resistance of 3.33 k2? The resistivity of tungsten -3 is 5.62 x 10-8 Q-m. length of the wire: m
4. A conductor of radius r, length and resistivity phas resistance R. It is melted down and formed into a new conductor, also cylindrical, with one fourth the length of the original conductor. Find the resistance of the new conductor.
1. Conductor Resistance: A copper wire with a length of 5 meters and a cross-sectional area of 3 × 10-6 m² has a resistivity of 1.68 × 10-8 Nm. Calculate the resistance of the copper wire. 2. Resistor Temperature Dependence: The resistance of a tungsten filament in an incandescent light bulb is 50 ohms at room temperature. If the temperature of the filament increases, and its resistance becomes 75 ohms, calculate the percentage increase in resistance. 3. Material Comparison: Two wires, one made of aluminum and the other of copper, have the same length and cross-sectional area. If the resistivity of aluminum is 2.82 × 10−8 N · m and the resistivity of copper is 1.68 × 10-8 N · m, compare the resistance of the two wires.
1. A certain geophysical technique determines the electrical resistivity of the ground by measuring the voltage, V, and current, I, between electrodes separated by a distance, a. These measurements are related to resistivity by the equation, resistivity = 2za (VI). 1.00 +0.01 meters, what If V = 0.512 +0.01 volts, I–0.00684 ± 0.0001 Amps, and a = is the uncertainty in the resistivity. (Note: The units of resistivity are ohm-meters. The numbers in this problem are given in such a way that no unit conversions are necessary.)
1. What is the resistance (in Q2) of a 34.0 m long piece of 19 gauge copper wire having a 0.912 mm diameter? 2. A resistor made of Nichrome wire is used in an application where its resistance cannot change more than 1.80% from its value at 20.0\deg C. Over what temperature range can it be used (in \deg C)? (Lowest and highest temperature)
003 A wire is made of a material with a resis- tivity of 4.18635 x 10 2 - m. It has length 5.78293 m and diameter 0.78225 mm. What is the resistance of the wire? Answer in units of 2.
1. A tungsten wire has a radius of 0.072 mm. When 128 V is applied across the ends of the hot wire, a current of 3.00 A is produced. How long is wire? (The resistivity of tungsten is 2.65 × : m 5 cci16 cm) ceil6 ceil6 cc
3. Look up tabulated conductivities (or resistivities) of copper, silver, and aluminum at 20 °C and calculate the resistance of a copper wire that is 2 meters long with a1 mm diameter. Repeat your calculation for silver, and for aluminum. The density of free electrons is 8.5x1028 particles/m3 for copper, 5.86x 102 m-3 for silver, and 18.1x1028 m-3 for aluminum. For a potential difference of 5 volts, how do the electron drift velocities in each of the three wires compare with one another?
5) Please need the correct to this problem with full explanation and methods how you get the answer, please.

SEE MORE QUESTIONS