Please solve within hour .Urgent 6.* Figure 6 shows two plates of thickness t = 6 mm and width (into the paper) 50 mm thaare joined by a bolted lap joint. The joint is loaded by a tensile force P = 7.0 kN. Find thmaximum tensile stress in the joint. If the bolts are considered to be circular with a diameter o8 mm, what is the maximum normal stress along the axis of the two bolts?(Ans: 160 MPa; 420 MPa)P88-Figure 688P

please refer handwritten solution

6.* Figure 6 shows two plates of thickness t = 6 mm and width (into the paper) 50 mm tha are joined by a bolted lap joint. The joint is loaded by a tensile force P = 7.0 kN. Find the maximum tensile stress in the joint. If the bolts are considered to be circular with a diameter o 8 mm, what is the maximum normal stress along the axis of the two bolts? (Ans: 160 MPa; 420 MPa)

6.* Figure 6 shows two plates of thickness t = 6 mm and width (into the paper) 50 mm tha are joined by a bolted lap joint. The joint is loaded by a tensile force P = 7.0 kN. Find the maximum tensile stress in the joint. If the bolts are considered to be circular with a diameter o 8 mm, what is the maximum normal stress along the axis of the two bolts? (Ans: 160 MPa; 420 MPa)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The vertical distance above a reference datum to a point is called the point’s
Please solve carefully , Important.
Draw a circular hole of 2cm deep and give dimensions to it.
PLEASE WRITE LEGIBLY, COMPLETE SOLUTIONS WITH DRAWING THANK YOU! A car weighing 9 kN travels at 80 km/hr. At the foot of an incline of 10%, the engine stops. Determine: a – acceleration. b – time for the car before it stops. c – distance traveled by the car before it stops.
Please give me answer in half hour otherwise I wil report
Solve it pleas
1 The basic drilling process is that a at the bottom of_ grinds a hole through the rock layers.
Q1. The part shown below will be turned in two machining steps. In the first step a length of (50 + 50) = 100 mm will be reduced from Ø100 mm to Ø80 mm and in the second step a length of 50 mm will be reduced from Ø80 mm to Ø60 mm. Calculate the required total machining time T with the following cutting conditions: Cutting speed V=80 m/min, Feed is f=0.8 mm/rev, Depth of cut 3 mm per pass. Ø100 Ø80 Ø60 50 50
Create a list of operations for the blueprint provided below. The list of operations must be in chronological order. • All units are in millimeters• Drill depth: 15mm• Raw material dimension: o Body: 65mm longo Cap: 30mm long• Note: Some corners are chamfered so don’t forget to include it in operations
DESCRIPTIVE GEOMETRY
Please solve it complete please don't copy paste