6. Cables AB, AC, and AD hold the balloon in the position shown. If the balloon exerts an upward force of 5000 N at the point of concurrency of the three cables, find the magnitudes of the tensile forces on the three cables TAn, TAC, and TAD. Hint: The resultant of the cable tensions is force exerted by the balloon at point A but opposite in direction. 560 m 4.20 m 3.30 m 4 20 m 2.40 m y

Q: A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B,…

A: Given  TAB= 110 lb

Q: PROBLEM 2: Refer to Example 4.9 page 131, and Determine the force in HI using section 1-1. Having…

A:

Q: Determine the force in the cables needed to support the 450-lb crate as showin in (Figure 1) Hint:…

A: Given weight of W = 450 lbIt is asked to determine the forces in the cables.

Q: 0.15 m 0.4m 0.2 m 03 m 0.5 m 0.25 m 0.2 m

A: The position vectors and unit vector are as follows: rCD=(-0.2i-0.3j+0.25k) munit…

Q: We have a table that we seek to lift with a pulley. The table is uniform, with a weight of 73…

A:

Q: 5.0 The truss figure shown is pinned to the wall at point F, and supported by a roller at point C.…

A: Load act at point A= 80 kNLoad act at point B= 60 kN

Q: Cables CE and BF along with the ball and socket at A support the rigid bar ABCD. (Due to the nature…

A: Calculate the position vectors for the cables CE and BF. The position vector for cable CE is ece…

Q: Suppose a BAF 5 gage was chosen for inventorying a stand. What might you assume about the size and…

A: BAF (Basal Area Factor) is a measure of the area of a tree's cross-section at breast height (usually…

Q: 10 kip E | D 000 4 ft 7 kip F 000 000 4 ft A В 000 Which of the following is closest to the…

A:

Q: The wall crane supports a load of 700 lb. determine the horizontal and vertical components of the…

A:

Q: Q5) Three cables are joined at the junction ring C show in Fig, determine the tensions in cables AC…

A:

Q: 2. Determine the force in each member of the space truss shown in the figure. The truss is supported…

A: Given:- The truss is supported by a ball-and-socket joint at A A slotted roller joint at B and a…

Q: Show that, when a frame supports a pulley at A, an equivalent loading of the frame and of each of…

A: Given: Two different pulley systems as shown in figure a and b

Q: 2. The force F = 1600i + 400j (lbs) acts at point A. What are the tensions in the three cables? F D…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.