6. A forced draft centrifugal fan draws air at 1.32 cubic meter/sec towards a combustion chamber of a steam generator. The static pressures are 15mm. water below atmospheric at suction and 10mm. water above atmospheric at the discharge. The inlet duct is 30cm in diameter and the discharge duct is 27cm in diameter. The fan mechanical efficiency is 70%. The air is measured at 25 degrees Celsius and 760mmHg. Determine:

6. A forced draft centrifugal fan draws air at 1.32 cubic meter/sec towards a combustion chamber of a steam generator. The static pressures are 15mm. water below atmospheric at suction and 10mm. water above atmospheric at the discharge. The inlet duct is 30cm in diameter and the discharge duct is 27cm in diameter. The fan mechanical efficiency is 70%. The air is measured at 25 degrees Celsius and 760mmHg. Determine:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

How many piston does a two stroke engine have
1- In a bike, the __________ is converted into power. A.kinetic energy B.heat energy C.work energy D.potential energy
Q1: The working pressure is depending on the outside load, if the surface of the piston is 5cm², the mass is 10kg, how much is the working pressure of the hydraulic transmission system?
Descriptive Question Identify Kelvin-Planck Statement for the Second Law of Thermodynamics. hp
____ is a measure of the rate of change of the ____ with respect to position.
10. When using a thermal flow meter to measure mass, the O Faster Slower O Neither O Both the fluid flows the cooler the temperature becomes.
a) Write a short note on balancing of reciprocating masses.
2) A compressor system which is controlled by starting-and-stopping is composed of a compressor with pumping capacity of 50 m3/min of free air and a receiver tank of 20 m3. The circuit demand is 25 m3/min of free air. No of start/stops is required to be 15 every hour. If the maximum line pressure is 8 bar gauge, what must be the low level pressure ?
The value that tells you the planned value of work that has actually been completed is the AC PV EV SV
It describes the rate at which an object rotates and the direction it rotates. A. Angular acceleration B. Angular displacement C. Angular velocity D. Angular position
Compare Gasoline Engine from Diesel Engine.
31 The SI unit for all energy measurement is called? a. Joule b. calorie c. BTU d. watt