6. A 200-N block in contact with a level plane is acted upon by a horizontal force P = 100N. The 6-0.20. A. In what time will the velocity of the block be increased from 4m/s to 10m/s? B. What will be the velocity of the block after 35, starting from rest? C. How long will the block travel if after 3s P is removed?

6. A 200-N block in contact with a level plane is acted upon by a horizontal force P = 100N. The 6-0.20. A. In what time will the velocity of the block be increased from 4m/s to 10m/s? B. What will be the velocity of the block after 35, starting from rest? C. How long will the block travel if after 3s P is removed?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An experimental device imparts a force of magni tude F = 225 N to the front edge of the rim at A to simulate the effect of a slam dunk. Determine the moments of the force F about point 0 and about point B. Finally, locate, from the base at 0, a point C on the ground where the force imparts zero moment.
Determine the reactions at A and E if P = 920 N. The reactions are positive if to the right or up, negative if to the left or down. 3500.78 N, 3101.77 N 3050.78 N, 3110.77 N 3050.87 N, 3011.77 N 3500.78 N, 3101.77 N
SOLVE THIS USING CBM. THANK YOU. The roof beam of a building is subjected to the loading shown. If a 3/8-in. deflection is permitted at the cantilever end before the ceiling & roofing materials would be damaged, determine the required moment of inertia for the beam. Use E = 29,000 ksi. 24 kips 0.72 kip/ft 0.48 kip/ft B
The 58 kg uniform beam (slender rod) is lying on the floor when the man exerts a force of F = 336 N on the rope, which passes over a small smooth peg at C. a) Determine the initial angular acceleration of the beam, in rad/s2. b) Find the horizontal reaction on the beam at A (considered to be a pin) at this instant. Express your answer in Newtons.
Q5/A) From the figure below, Replace the force and moment system acting on the beam by an equivalent resultant force, and find where its line of action intersects the beam, measured from point A. -1.5 m 1.5 112 kN 9 kN/m m 1.5 m →1.5 m 1.5 m B
USE DOUBLE INTEGRATION AND AREA MOMENT METHOD. THANK YOU. The roof beam of a building is subjected to the loading shown. If a 3/8-in. deflection is permitted at the cantilever end before the ceiling & roofing materials would be damaged, determine the required moment of inertia for the beam. Use E = 29,000 ksi. 24 kips 0.72 kip/f 0.48 kip/īt B 10 10
The mechanism for a car window winder is shown in the figure. Here the handle turns the small cog C, which rotates the spur gear S, thereby rotating the fixed-connected lever AB which raises track D in which the window rests. The window is free to slide on the track. If the handle is wound at 0.5 rad/s, determine the speed of points A and E and the speed vw of the window at the instant = 40°. - D 20 mm 0.5 rad/s 50 mm B 0 -200 mm -200 mm A E
Blocks A has a mass of 35 kg and B has a mass of 20 kg. All contact surfaces have the same coefficient of friction of 0.25. Determine the force P needed to cause impending motion of block B to the left. Use 0 = 8°and B = 10° A 100
Determine the vertical reaction at E for the beam shown using the slope-deflection method. 20 kN/m 60 kN A E B C D -8 m+4m+4m-| -8 m El = constant E = 70 GPa 1= 800 (106) mm4 O a. 111.2 kN O b. 164.7 kN O c. 78.8 kN O d. 25.3 kN
At the instant shown, the slider D has a velocity of 3 ft/s up the channel and its speed is decreasing at a rate of 0.5 ft/s². Determine at this instant: a. The angular accelerations a and acp (include magnitude and direction) b. The acceleration of point C in Cartesian form. Solve the problem using any method. 3.a a AB acD 3.b ac = = 10 in. 8 in. A B 12 in. D 30°
The 5 kg block A travels to the right at va = 0.61 "/sec at the instant shown in the figure. If the coefficient of kinetic friction is f = 0.2 between the surface and A, determine the following: а. the velocity of block A when it has moved 1.2 m. Answer in m/sec. b. Acceleration of block A and B. Answer in m/sec?. c. Magnitude of the force in the cable connected at block A. Answer in Newton. Block B has a weight of 9 kg. A B
The slider bar AB is attached to a collar at A and is fited with a wheel at B. The collar has velocity of 500 mm/s downward and the speed of the collar is decreasing at a rate of 150 mm/s2. The angular velocity of the bar is 3.20 rad's CCW and the velocity of point Bis 0.400 to the right. A 200 mm B Which of the folowing is the conrect acceleration (m/s"2) of point B on bar AB? (A) 0.290 (B) 2.74 (C) 0.372 (D) 0.0391 4,