6 kN/m D 1.5 m- 0.75 m - 3.75 m - Fig. P6.1

Q: Replace the loading by a single resultant force, specify the location of force measured from point…

A: Note that, the center of mass of a uniformly varying loading (UVL) acts at the position of two-third…

Q: The turnbuckle is tightened until the tension in the cable AB equals 2.1 kN. Determine the vector…

A:

Q: Q3( , - Determine the resultant of forces system shown in Figure with its direction and locate it…

A: To find :  The resultant of forces, direction and location from point C. FBD: The FBD of resultant…

Q: Determine the resultant of the force system shown. A = 41 KN/m B= 19 KN/m c= 3 m d= 4 m

A: Find the resultant force .

Q: The yield stress for a metal changes from 410 Nmm^-2 to 670 Nmm^-2 when the average grain diameter…

A: Given:σy1=410 N/mm2    σy2=670 N/mm2d1=0.053 mmd2=0.037 mmdavg=0.045 mmσy=560 N/mm2

Q: Problem 4: Replace the loading system with an equivalent force (no moment), and specify its location…

A: Draw FBD

Q: Statics of Rigid Bodies (Round off to two (2) decimal places. Include negative sign (-) if the…

A: The Force in the line AB is, To determine:y scalar component of F

Q: body moving at 0.500 C with respect to an observer disintegrated into two fragments that move in…

A: According to the addition of velocities, the velocity of the fragment moving with velocity 0.600c is…

Q: Q3 / A: 2. For the force system as shown in fig.(3-a) below ; Find the location of the resultant…

A: Law of Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the…

Q: Oー て (a) The light Boom AB 15 attached-to a vertcal unl 470 and supponted by twe ables at B.A Foroe…

A:

Q: of the transmission tower. The tension force in cable AC is 8 kN. Determine the required tension…

A: Given data Tension force in cable AC = 8KN

Q: FIND:The Resultant of the 5 concurren? forces ShoWN above. Specify beth magnitude and direction in…

A: First resolving all the forces long the vertical and horizontal direction as shown in figure:

Q: (25) 1. Draw the free body diagrams for the following system. Write the force equations. X:(t) +…

A: Free Body Diagram is the representation of forces maybe gravitational, applied or reactions and…

Q: Prob. 3: Determin the magnitude and diredan the resultant forces shown in Big 450 N 40 35 40 35 N 00

A:

Q: * when we have smooth surface at the contact to the body, we will have one tangent force to the body…

A: To check: Whether the statement is true. Given: The statement is "when we have smooth surface at the…

Q: tatics of Rigid Bodies (Round off to two (2) decimal places. Include negative sign (-) if the answer…

A: The unit vector is,The Force in the line AB is,

Q: ^*) Determine the resultant of forces system shown in Figure below and locate it with respect to…

A:

Q: 70 N.m Y 30 N 70 N M. (10, 20) (25, 10) (-10, 6) X. 40 N.m (5, -5) (-15, 15) 90 N 3. DETERMINE THE…

A:

Q: Determine the magnitude of the resulfant tore of the coplanar force system Shown In the fiqure below…

A:

Q: Find the resultant of the concurrent forces R and S for which the direction is specified by slope,…

A:

Q: Determine the components of the moment (Mx, My, Mz) that the F force will create at the point C in…

A:

Q: Detemire the magnitude of the resaltant force (nN) OF the coplanar fore system shaon in the fiqure…

A:

Q: Determine the moment produced by force F al segment 4R ofthe nine asse mbly cemblb Evpressthe

A:

Q: Determine the resultant R of the system of distributed loads and locate its line of action with…

A: Draw the diagram replacing all uniformly varying load and uniformly distributed load with point…

Q: For the same problem given in Part A, if the support at B creates a reaction force Bx and By as…

A:

Q: 0.5 m B Example Replace the force system acting on the post by a resultant force, and specify where…

A: