-6 A 92 (b) 12 n 18 N 4 A (d) FIG. 6.89 Problem 23. using the current divider rule. find the unknown currents for the net work of fig. 6.89

Q: Use mesh analysis to calculate the currents in the circuit shown in Figure below.

A: Applying KVL at both loops: Loop:1(lower): 10-80i1-20i2=0 10-80i1-20(i1-i3)=0 10-80i1-20i1+20i3=0…

Q: find v, and i, in the circuit shown below. 6A O 22

A: Node: The meeting point of more than two branches in a circuit is referred as a node. At that node…

Q: We want to analyze the circuit in Fig. 6.30(a) to determine the voltages at all nodes and the…

A:

Q: 9. For the circuit shown, when the switch is open (R, and R. disconnected), V = 15 V. When the…

A: In this question,  We need to determine the value of resistance R2 and R4.  If voltage across R2 is…

Q: Given the information provided in Fig. 6.24: a. Determine R3. b. Find the applied voltage E. c. Find…

A:

Q: A 24V battery with 1Ω internal resistance, a 12V battery with 0.1Ω internal resistance and a 4Ω…

A: Calculate the resistance of the lamp load. RL=V2P=12 V260 W=2.4 Ω

Q: In Circuit below, :6.5V, Ry= 75 R,= ISR R3=502, Find Ry, If PT, Vs 73) k3 Ry 4 IT

A: Given Data: R1 = 15 ohm R2 = 50 ohm R3 = 50 ohm R4 = 75 ohm VT = 6.5 V

Q: We want to analyze the circuit in Fig. 6.30(a) to determine the voltages at all nodes and the…

A:

Q: Resistors are said to be connected in parallel when two circuit elements connect at a single node…

A: Consider a node pair, A and B, with voltage VA and VB

Q: 1. What is the condition under which the superposition theorem can be applied?

A: As per Bartleby guidelines we are allowed to solve only one question, please ask for the rest again.

Q: labäi In the series parallel circuit shown in Fig.6. the supply voltage and drop voltage across the…

A: The parallel combination of 10 and 8 ohm branch and the parallel combination of 24, 12 and 8 ohms…

Q: Find the equivalent resistance in ohms between the terminals A and N in figure

A: We will remove resistance between A and N and we will find Thevenin equivalent resistance between A…

Q: Figure 6-35 R= 1.5 k. R= 10 kn V = 36 VE R, = 15 kn R= 10 kn R= 15 k. R, = 1 kn R = 5 ka 6-26 In…

A:

Q: 6V Use Norton's theorem to find V, in the network given below. 6 k 2 k 2000/ 3 mA 4 ΚΩ 4k02

A: In this question we need to find the voltage Vo using Norton theorem.

Q: In the circuit in Figure 7, calculate the value of R, for maximum power transfer 4 V 60 RL O2 A

A: Since, it is only asked to find the value of RL in the question, thus solving the relevant question…

Q: 300 N: R1 230 V 300 0 R2 Figure 6.4 300 Ω R1 230 V 600 Ω3 R2 Figure 6.5 300 N R2 230 V 300 N: 600 N…

A:

Q: Example: 6.2 Use mesh analysis to find the current io in the circuit in the below figure 102 24 2 24…

A: We solved this problem by mesh analysis by inspection method

Q: Homework: Apply mesh analysis to find i in the below figure. 6.1 100 ww 6 V 20

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed loop network,…

Q: Obtain network simplification after successive source transformation of the given figure

A: In a circuit, the voltage-to-current source and current-to-voltage source transformation can be…

Q: Given the information provided in Fig. 6.24: a. Determine R3. b. Find the applied voltage E. c. Find…

A: The given circuit diagram is shown below,

Q: Find the voltage V, across the resistor R = 6.402 in the following circuit using superposition…

A: Superposition theorem states that a circuit with multiple sources is same as the sum of simplified…

Q: 6. Find the power dissipated when: (a) a current of 5mA flows through a resistance of 20 kn (b) a…

A:

Q: PROBLEM: 1. Using Superposition Theorem, solve for Vout. Computation: a) 5V only Vout' 6) 5V is…

A:

Q: oblem #6: a) Formulate mesh current equations from figure below, b) Solve for la and Ig, c) nd Vx…

A:

Q: H.W. (6.2): Using the information provided, find the unknown quantities for the circuit shown in…

A: Ohm's Law states that the voltage across a resistor is directly proportional to the current flowing…

Q: 102 42 207 28 V 82

A:

Q: 6.13 For the network shown. a) Find the current through each branch. b) Find the total resistance as…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Design an ammeter with a range of 0-5mA, 0-10mA and 0-20mA from an ammeter whose full scale current…

A: We need to find Design a multi range ammeter for given current

Q: Four resistors R1=190 ohm, R2=330 ohm, R3=330 ohm and R4=50 ohm are connected to a 36 V battery as…

A:

Q: 4. 62

A:

Q: May I ask, how did they arrive to the answer of Vb = 5.04V and Vc = 9.8 V (in picture 1). Enlighten…

A:

Q: 19. Use nodal analysis to find vbe in the circuit of Figure 6.52. 1 sin2pi100t a 75 b HH 20 nF 82 d…

A: As per the guidelines of Bartleby we suppose to answer first question only since the remaining…

Q: 6-24 In Fig. 6-34, solve for R,t, Vi, V2, V3, Vas V5, V6sl l4slg, and Ig. Figure 6-34 R, = 120 2 R3…

A: Circuits

Q: . Comect the CCT shown below. Fig (-1) a - Measure ","," practically. T. By using delta-star…

A: The given delta network is given so we find Resistance for star network…

Q: Figure 6-16 b. What is the effect on the total resistance of the network of Fig. 6.16 if an…

A: Since the current divided all resistance in this circuit are connected in parallel

Q: Q2) Combine sources and use the voltage division principle to find Vab in the circuit

A: First it is required to combined the source and the resistance According to the voltage division…

Q: The equivalent resistance across terminals AB is: a. 6.75 Ω b. 10.0 Ω c. 7.24 Ω d. 9.31 Ω

A: If resistors R1 , R2 , R3 are connected in series than equivalent resistance is R1 +R2 + R3. If…

Q: 6.1 State Thevenin's theorem. 6.2 Use Thevenin's theorem to determine the current flowing through…

A:

Q: Prob. 3 A moving coil meter movement has the characteristics an internal resistance of 500 ohms and…

A:

Q: Compute for the total power and power in each resistor

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.