5/85 Determine the volume V and total surface area A of the solid generated by revolving the area shown through 180° about the z-axis. Ans. V 1.775(10) mm³, A = 105 800 mm² 40 mm 30 mm

Q: Could you show the calculations for the table

A: The discharge through the section = Q = 100, 150, 200, and 250 cfs The slope of the section = S =…

Q: how did you get 1.5 for the first part

A: In the original question it is stated that Vmax=2 Vmin In the solution, the following is given.…

Q: Define integer ambiguities.

A: Answer The integer ambiguities are used in GPS & GNSS surveys.

Q: What are Cole values

A: Solution: COLE stands for The Coefficient of linear Extensibility.  It is used to measures the soil…

Q: What is Landsat and name 2 Civil Engineering Applications can it be used for?

A:

Q: some examples of the term OFFSET

A:

Q: What is sumps?

A: Sump collects building up underground water so that it can be pumped aside from a finished building…

Q: orry I cannot understand can u pls write it down？

A:

Q: What are Quantity Variations?

A:

Q: What is Micropiles?

A: - A Micropile is a type of friction pile having diameter less than equal to 305 mm which can be…

Q: Define a logic loop.

A: The loop means a continuous order of formations which can repeat the work until a certain…

Q: The state of stress at a point in a member is shown on the rectangular stress element in (Figure 4)…

A: 1. Deactivate the voltage source (V1):Set the voltage source V1 to zero (0 V). This means the…

Q: Can you please redo this and explain how you got what you got? I dont understand concept and show…

A: To draw a cross-section AA' and BB' for the given section.

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.