5:30 AM P • G • "(-). 40. 907 84 Expert Help EaEDnD#9140 05:09 O-SH 22 41 ww Assuming the initial current flowing in ristor is To-10 Calculate ict) and Tx(t) h the circuit ALIVE. 0.5H 27 41 ' Assuming the initial current flowing in resistor is To-10A Calculate ict) and be (t) in the circuit Above. Sorry for not solving your problem, the used Ticket has been refunded to your account. > +1 ticket

The data-input and data-select waveforms in Figure 7 are applied to the multiplexer. Determine the output waveform F in relation to the inputs.

Consider a 1 into 4 de-multiplexer.The data input and selection line waveforms for the demultiplexer are given below. Draw the corresponding output waveforms (for D0 to D3). Data in SO DO D3 Note: You need to draw the waveforms on paper. Take the photo and then upload. A- B I

C'uk Converter Design A C'uk converter has an input of 12 V and is to have an output of - 24 V supplying a 60 W load. Select the duty ratio, the switching frequency, the inductor sizes such that the change in inductor currents is no more than 12 percent of the average inductor current, the output ripple voltage is no more than 1.5 percent, and the ripple voltage across C1 is no more than 3 percent.

Why this happening to my circuit? I am inputting a 0-3.3 V sine wave into my voltage follower circuit using NE5532P. At the output I am seeing 0-3.3 V sine wave as expected. However, when I add a 1000 uF capacitor and a loudspeaker to listen to the sine wave my wave is clipped and its reading -800 mV for min and +680 mV for max on the oscilloscope. How do I fix this so that I only listen to 0-3.3 V sine wave? I'm in the lab and this is confusing to me.

I need a clear step by step answer please and explanation please on how to obtain the values of Th and Tl and Vl

The serial data-input waveform (Data in) and data-select inputs (S0 and S1) are shown in Figure Determine the data-output waveforms from D0 through D3.

double clipper circuit  Zener diodes 1N4733A has a voltage of 5.1 V and 1N4735A has a voltage of 6.2 V with a resistor R=300ohms has been used. you may like to increase the input to a 12 VRMS AC source in order to see the clipping at 7volt. Please, Do the theoretical calculations and plot the expected waveforms by hand. ( I have its multisim design and only needs theoretical calculation and hand drawn graph of it to compare to its data that I have collected  from multism.) Thanks

Do it soon , now ( course” Digital Electronics Technique

Answer in handwriting