A uniform 80N beam that is 5 m long is attached to a wall by a cable as shown in the figure. The system is in staticequilibrium. What is the tension on the cable?O 66.7NO 784N50NO 400N80N 53"5 mA uniform 80N beam that is 5 m long is attached to a wall by a cable as shown in the figure. The system is in staticequilibrium. What is the tension on the cable?O 66.7NO 784NO 50N

Answered: Image /qna-images/answer/06348590-9e1c-42b6-a15e-46adbf8ece9a.jpg

Answered: 53° 5 m A uniform 8ON beam that is 5 m…

53° 5 m A uniform 8ON beam that is 5 m long is attached to a wall by a cable as shown in the figure. The system equilibrium. What is the tension on the cable?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Modeled after problem 5 in the Problems_Torque_Statics: A 13.98-m-high and 12.18-m-long wall under construction and its bracing are shown in the figure. The wall is in stable equilibrium without the bracing but can pivot at its base. Calculate the force exerted by each of the 10 braces if a strong wind exerts a horizontal force of 586.31 N on each square meter of the wall. Assume that the net force from the wind acts at a height halfway up the wall and that all braces exert equal forces parallel to their lengths. Neglect the thickness of the wall. The angle between the braces and the wall is as shown in the figure as 35 degrees.
A uniform beam of length 1.0 m and mass 10 kg is attached to a wall by a cable as shown. What is the tension in the cable? What are the horizontal and vertical forces at the point where the wall and beam meet?
A 13.6 kg. 3.6 m long seesaw bar (assume that the bar is uniform) is perfectly balanced upon a support that is 0.2 m to the left of its center. There is a 6.5 kg block sitting on the far right side of the seesaw. How large of a mass do we need to place on the far left of the seesaw for it to be balanced?
The diagram shows a 7.0 meter log leaning on a rock. The wieght of the log is 780 Newton's. A 200 Newton boy walks up the log from the point where is touches the ground. He finds that he can only walk 5.0 meters up the log before it starts to tip over the rock WHrer is the center of gravity of the log located?
A uniform rod AB of weight 500 N and length 4.0 m is supported at two points P and Q as shown below. AP = QB = 0.80 m. A man of weight 800 N is walking from Q to B. Find the maximum %3D %3D distance x from Q the man can walk before the rod topples about Q. P Q A 1 -| × |- O 0.4 m O 0.8 m O 0.75 m O 0.6 m
Hi I needed help with this question. As shown in the figure below, a uniform beam is supported by a cable at one end and the force of friction at the other end. The cable makes an angle of ? = 30°, the length of the beam is L = 2.00 m, the coefficient of static friction between the wall and the beam is ?s = 0.600 and the weight of the beam is represented by w. Determine the minimum distance x from point A at which an additional weight 2w (twice the weight of the rod) can be hung without causing the rod to slip at point A. X=?
B-3 Jae, whose mass is 65.0kg is standing Im from the end of a uniform diving board 8m long. The diving board is supported at point 'A' by a pin and at point B by a frictionless wedge as shown on the figure. The diving board has a mass of 100kg. Jaer A Find the magnitude and direction of the force of the supports on the board at points 'A' and B. Imk 2m 5m Apply the static equilibrium conditions to the Jae+beam system. 99+ 團 op
The top of the folding workbench has a mass of 36 kg with mass center at G. Calculate the magnitude of the force supported by the pin at E. 225 mm D G Answers: E = F E 670 mm 1000 mm H i N B 805 mm
In exercise physiology studies, it is sometimes important to determine the location of a person's center of gravity. This can be done with the arrangement shown in the figure below. 2.00 m A light plank rests on two scales that read F = 380 N and F = 280 N. The scales are separated by a distance of 2.00 m. How far from the woman's feet is her center of gravity? Need Help? Read It
Two children of mass 21 kg and 26 kg sit balanced on a seesaw with the pivot point located at the center of the seesaw. If the children are separated by a distance of 2 m, at what distance from the pivot point is the small child sitting in order to maintain the balance? m
Ladder Slip? A 3.0-m-long ladder leans against a frictionless wall at an angle of 60°. What is the minimum value of the coefficient of static friction with the ground, that prevents the ladder from slipping? \L=3.0 m dz Center of mass • net = 0 about this point. 60° Gravity acts at di the center of mass. ***** Static friction prevents slipping.
The center of gravity of Kelly's outstretched arm is located 21 cm from the axis of rotation in her shoulder. Her arm has a mass of 4.2 kg and is 56 cm long. Assuming the deltoid's force is horizontal, what is the magnitude of the force her deltoid muscle must exert on Kelly's upper arm so she can hold a 6.0 kg mass stationary 15 degree above the horizontal as shown? Her deltoid muscle attaches to her upper arm at a point 18 cm from her shoulder joint. 6 kg 15° 21 cm Fdeltiod