5/199 A fresh-water channel 10 ft wide (normal to the plane of the paper) is blocked at its end by a rec- tangular barrier, shown in section ABD. Support- ing struts BC are spaced every 2 ft along the 10-ft width. Determine the compression C in each strut. Neglect the weights of the members. D 2' B 2' 2' A/60° 60° Problem 5/199

Q: 3. Determine bar forces GE, GF, EF, ED, FD, and FB. Use the method of joints. D 25 KN 30° B 30 60°…

A:

Q: 18 12⁰ PLAN SECTION =1 S B1 B2 B3 B F 10 cantilevered beams columns W The load per foot on Joists…

A: Dead load, DL = 30 psf Live Load, LL = 40 psf Allowable stress in the column, Fa = 1000 psi

Q: The dimensions of the beam are limited to b=12 in., d=18 in. If the maximum positive moment (Mu) is…

A: Calculate the moment capacity based on maximum area of steel Asmax=0.8fc'bβ1dfy38…

Q: 11-11. The brick wall exerts a uniform distributed load of 1.20 kip/ft on the beam. If the allowable…

A: Given: Allowable bending stress = 22 ksi, Allowable shear stress = 12 ksi

Q: The floor system used in a school classroom. The live load is 0.4 k / ft2 and the slab is…

A:

Q: If P = 114 kN, determine the normal stress produced at point H of the pier support shown. P 500 mm

A: Given : P = 114 kN To find : Determine the normal stress produced at point H ?

Q: A 200 mm thick one-way reinforced concrete slab overhang simple support. The span

A:

Q: The floor system used in a school classroom. The live load is 0.4 k / ft2 and the slab is…

A: Step 1:see step by step procedure  Step 2: Step 3: Step 4:

Q: The value of VA, Vs, H, Mc, Nc, and Dc

A: The figure given in the question is as follows

Q: Prob. 4-162 1 m W1 60 kN 80 KN -2.5 m- -3.5 m 50 kN 1 m W2

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The floor system used in a school classroom. The live load is 0.4 k / ft2 and the slab is…

A:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.