50 cm V2. P2 = Pa 50 cm 2. V1. P1

Q: A pipe of diameter 10cm conveying 200 liters/s of water has bend of angle (θ = 90⁰) and θ = 0⁰…

A: GIVEN:diameter d=10cmP1=15N/cm2P2=10N/cm2

Q: A Francis radial-flow hydroturbine is being designed with the following dimensions: r2 = 2.00 m, r1…

A: The data given is,

Q: Water flows around the vertical two-dimensional bend with circular streamlines and constant velocity…

A: Given data: v=10 m/sp1=62 kpa

Q: A velocity field is described by the following equations: 10y -10x U = x²+y2 V = x2+y2' and w=0 (a)…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: For the sprinkler shown, find a. the torque required to hold it steady, and b. the rotation rate in…

A:

Q: .A 45° reducing pipe-bend (in a horizontal plane) tapers from 600 mm diameter at inlet to 30 mm…

A: Diameter at outlet will not be 30mm because if the diameter is 30mm pressure becomes negative at…

Q: 4. A tank is full of water and open at the top as shown in the figure. There is a frictionless…

A: Solution: Given Data: z1 = 10 m P1=P2=PatmV1=0z2=0

Q: The 28-in-diameter pump in Fig. at 1170 r/min isused to pump water at 20°C through a piping system…

A:

Q: Question 3 Given: WA = 10 N WB = 20 N VoA = 2 m/s Hk = 0.2 Find: VA when A has moved 4 meter. B

A:

Q: In the spillway fl ow of Fig. , the fl ow is assumeduniform and hydrostatic at sections 1 and 2. If…

A: For mass conservation                                     v2=v1h1h2=5v10.7=7.14 v1 Now applying the…

Q: Q3 For the given setup find the minimum force F, required to keep the walls in equilibrium. Assume…

A: Given:To find:Minimum force Fx required to keep the walls in equilibrium.

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.