5.55 In the circuits shown in Fig. P5.55, transistors are characterized by | V] = 2 V, K WIL = 1 mA/V, and 2 = 0. (a) Find the labeled voltages V, through V,. (b) In each of the circuits, replace the current source with a resistor. Select the resistor value to yield a current as close to that of the current source as possible, while using resistors specified in the 1% table provided in Appendix G. Find the new values of V, to V. +10 V 4 kn +10V I mA 2 mA -10 V (a) +10V +10V 2 mA 40

Q: choose the correct Statement a. if  the load of PV module  Decreases, then its Output current…

A: On PV module, voltage will be constant.  But load current depends on the light intensity, not load.

Q: I need help on this question

A: Given figure: To find average value of square wave: Average value of symmetrical wave over one full…

Q: The sum of the voltages over any closed loop is equal to Select one: а. 2V b. OV c. Infinity 21 / 30…

A: According to kirchhoffs  voltage law the algebraic sum of all the branch voltages around any closed…

Q: 1.35. A system has the input-output relation given by Show that this system is nonlinear. y = T{x} =…

A:

Q: Optical fibers are very reliable communication channels and they transmit data in… A. Analog B. Both…

A:

Q: Which of the following standards is not used for paging system?  POCSAG, ERMES, IS 95, FLEX

A: The given standards are: POCSAG ERMES IS 95 FLEX In this case, the standard(s) that are not used for…

Q: circuit 3-(33) Fnd the k porame ters for the gwen I, I, V, Rz

A:

Q: Calculate L for the coil if the induced emf is measured to be 2 V for a coll with 50 closed tums…

A: Given: induced EMF (V) = 2V  Closed Coil Turn (N) = 50   Time (dt) = 0.1 sec  Change in Current (di)…

Q: 3. Plot the values from Tables 1 and 2 on a graph with Ip on the y-axis and Vp on the x- axis. 4.…

A: The plots for data in tables 1 and 2 are shown in the figures below.