5.30 In the model of the hydrogen atom proposed by Bohr in 1913, the electron moves around the nucleus at a speed of 4x 106 m/s in a circular orbit of radius 7x 10-I" m. What is the magnitude of the magnetic moment generated by the electron's motion?

Q: Subject: Business process reengineering c) What is the benefit of spidar diagram & where it use…

A: perceptible conceptualize diagram support by systemize conception and notion reasonably to look a…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 14 m/s. The stage efficiencies are Cp…

A: Find the diameter of the wine turbine Output power P= 8kW Wind speed 14m/s Find the turbine…

Q: Since R1=8992.04ohm, R2=8155.31ohm and Ri=Infinite in the circuit given in the figure, write the…

A: The given circuit is, Here,

Q: An open circuit is occurred when: Select one: a. All of the answers. b. a pair of terminals not…

A: We need to select correct option for open circuit.

Q: A mass is connected by a spring and damper to the wall as shown in the following figure. The floor…

A: In this question,  We need to calculate the transfer function of the given system.  We are solving…

Q: B2. Determine the resistance of an aluminium coil of 1.4 cm as diameter consists of 15600 turns and…

A: We need to find out area and length and resistance of a wire .

Q: Determine total charge entering the terminal between t=3 s and t=6 s if the current passing the…

A: In this question,  Current in the terminal is given, find the charges entering in the terminal from…

Q: Current Attempt in Progress The figure shows a resistor of resistance R = 6.32 02 connected to an…

A:

Q: Based on the response curve, answer the following questions: (a) What can be said about the order…

A: The time response plot subjected to a unit-step input of a spring-mass-damper system. The peak value…

Q: what is the difference between earth and ground ?  describe in simple words.

A: The difference between earthing and grounding is that the term “Earthing” means that the circuit is…

Q: I need the answer in number 6 with complete solution and units based on the given problem. Also do…

A: Since it is asked to solve only 6th question, therefore the detailed answer is solved below…

Q: Do the following pole-zero plots belong to realistic physical systems? Justify your answer. -1 -2 -1…

A: Poles of the control system is those points where the gain of the system approaches to infinity. at…

Q: 6. What are the advantages and disadvantages of supercapacitors?

A: We have given the following problem What are the advantages and disadvantages of supercapacitors?

Q: Consider the possibility of extracting energy from 1 m3 of water. One approach would be to lift the…

A:

Q: What is source transformation in the electrical circuit?

A: Source transformation is the transformation which is used to simply the circuit when the circuit…

Q: A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional…

A: To determine the new resistance value of the metallic wire

Q: The incremental fuel costs, in dollars per megawatthour, for two units in a plant are given by dF dF…

A:

Q: List 3 different concepts of Electricity(gravity) not hydro generation using weights design.  Each…

A: Concept 1: Piezoelectricity Generation   Introduction: Piezoelectricity is a concept that…

Q: What is metastability? How to avoid this.

A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…

Q: Consider the circuit shown by the figure below where all batteries are ideal batteries. Find the…

A:

Q: Q4\ Design a multi range D.C. ammeter by using indirect method to give the following ranges IA, 5A,…

A: Design a multi range DC ammeter.  For range of 1A, 5A, 25A, 50A and 100A. If PMMC meter have…

Q: R, 2.2k R, 4.7k R, 470 R 470 15V R 1k R 4.7k Figure 2 Circuit 2 Schematic

A: The circuit can be redrawn as: So, the total resistance of the circuit is:

Q: Short Problem: Given a series circuit comprised of the following element: 63.88-ohm resistor.…

A: In this question,  Find the angle of the impedance?  If RLC are connected in series.

Q: In the example on page 33, we have one pole outside the unit circle, no poles on the unit circle,…

A:

Q: A solenoid has a length of 88cm and has a core of free air. It is wound with 4600 turns of wire and…

A: In this question we will find area of solenoid with given data .

Q: use both IEC and NEMA symbols. - Conductors crossing but not connected - Conductors crossing and…

A:

Q: An electric toaster works by radiative heat transfer. On each side of a four-slice toaster, there…

A: Considering the power is radiated in the form of heat. Then by the Stefan Boltzmann law the power…

Q: Two wires A and B made from two different materials have temperature coefficient of resistance equal…

A: Equivalent Resistance : The overall effectiveness of all resistors connected in an electric circuit,…

Q: Identify the circuits below and briefly explain each of its behavior. 1. R₁ www D₁ Efia at 2.…

A: The parallel combination of an Inductor and a Capacitor is usually called a tank circuit. This…

Q: Q) Design DC voltmeter by using indirect method with meter of 1002 and the full-scale deflection of…

A: we will use ohms law and KVL to find unknown resistance.

Q: Problem No.2 group Six group of batteries are in parallel. Each has 10 cells connected in series,…

A: Given that each group has 10 cells and each cell has emf of 6 V and resistance of 0.4 ohm. Total 6…

Q: illustrate charging by conduction and induction. Describe your materials and how the demonstration…

A: Given  We need to explain charging by induction and conduction. Please find the below attachment for…

Q: 4. According to electrical properties, a material is classified as valence electron/s. 5. According…

A:

Q: Q) give 5 to 10 reasons when the steady state error happened Subject name control system engineering

A: Given; Steady state error

Q: The 555 timer is mounted and connected to the power and ground terminals of the IC. The circuit…

A: The given circuit diagram is of Astable multivibrator using IC 555.   Requirement is R1 > 1kΩ R1…

Q: Post a response to the following discussion questions. The introductory course sessions have…

A: Solution of first subpart: It is asked to cite some sources of nonlinearities that arise in the…

Q: Z Your answer is partially correct. Try again. A block of mass m = 1.10 kg is dropped from height h…

A:

Q: 1. Resistance Measurement Choose a 10% (or a 5% tolerance if you don't have a 10%) tolerance…

A: Standard resistance available in market in between 20 and 45 Ohm is 20R 22R 27R 33R 36R 39R 43R 47R

Q: Could you please help me out with these questions? Thank You A typical 9 m hydro pole weighs…

A: Effect of biological system:

Q: 23.Compare between 1 ph IM and 3 ph IM. 24.Draw the equivalent circuit of 1 ph IM. 25. Write the…

A: In this question we will write about comparison between single phase induction motor and 3 phase…

Q: The cause of connection problems when using thermocouples for measurements done remotely (long…

A: Thermocouples Thermocouples are temperature measurement instruments used in industrial and…

Q: Wire to be used in buildings and homes in the United States is standardized according to the AWG…

A: A: To calculate the expression of diameter of the wire, simple the expression of gauge number using…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.