5.12-2 A solid circular pole is subjected to linearly varying distributed force with maximum intensity q. at the base and an axial compressive load Pat the top (see figure). Find the required diameter d of the pole if the maximum allowable normal stress is 150 MPa. Let q, = 6.5 kN/m, P = 70 kN, and L = 3 m. L 90

Q: Two solid bars support a load P as shown. Bar (1) has a cross-sectional area of A₁ = 3050 mm² and an…

A:

Q: The vertical compressive stress at a point in a soil is 100 kN/m² while the horizontal compressive…

A: Vertical Stress at point - 100 kN/m2 Horizontal stress at point - 62 kN/m2 To find-

Q: The stresses shown act at a point on the free surface of a machine component. Normal and shear…

A: Using transformation equation

Q: Problem No.1. The normal stress on plane pq of a prismatic bar in tension (see figure) is found to…

A:

Q: Two solid bars support a load P as shown. Bar (1) has a cross-sectional area of A₁ = 3750 mm² and an…

A: Given Area and stress in rod 1 is 3750 mm2 and 115 mpaArea and stress in rod 2 is 3150 mm2 and 130…

Q: The stresses shown act at a point in a stressed body. Assume stress magnitudes of Sx = 18 MPa, S, =…

A:

Q: The following shaft has a diameter of 60 mm, and it is made of Aluminum (G = 29 GPa). The shear…

A: Given, d=60 mmG=29 GPaτ= 200 MPaFOS=2.5ϕ=3 degree

Q: A 3 m B W 50 mm 3 m- 100 mm - Change the height of the cross section from 100 mm to 68.70 mm the…

A: Height of cross section = (5068.7) mmFind:(a) Maximum shear stress in the beam(b) Maximum bending…

Q: Part AB of the bar has a circular cross section with 15-mm radius, and part BC has a circular cross…

A: Objective: To determine the normal stress on perpendicular planes to the bar's axis in part AB and…

Q: For the cylindrical shaft shown, determine the maximum shearing stress caused by a torque of…

A:

Q: A steel pipe with an outside diameter of 115 mm and an inside diameter of 105 mm supports the…

A: Principal stresses: Principal stress is defined as the plane's zero shear stress. The principal…

Q: Problem 6. [Concepts: Spatially varying average normal stress, and integration] The bar has a…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.