5.11 A process of unknown transfer function is subjected to a unit impulse input. The output of the process is measured accurately and is found to be represented by the function Y(t)= te. Determine the unit step response in this process.

Q: An opposed louvre type damper is used to regulate air flow to a furnace in order to control the…

A: a) The PLC will read 5.778 mA as a feed back when the louvres are at 10 ∘ b) 12 mA is required to…

Q: A process that can be modeled as a time delay (gain=1)is controlled using a proportional feedback…

A: The general block diagram for a feedback control system is:

Q: For the transfer function in Fig. P4-14, the response Y (1) is sinusoidal. The amplitude of the…

A: Given Data  The transfer function diagram is given as : The amplitude  of the output wave is 0.6…

Q: Recall the stirred-tank heating process with variable on hold Recalculate the degrees of freedom…

A: Diagram for stirred tank heating process with variable holdup is shown below:

Q: Shown below is a chemical-sensing field effect transistor (FET) in the absence of an applied gate…

A: To find - The correct order in which Chemical Sensing FET generates a response to an analyte.

Q: Q5: Determine the transfer function H(s)/Q(s) for the liquid-level system shown in Fig. (5)…

A:

Q: Determine values for A and R from the step response

A:

Q: A chemostat is a continuous stirred tank bioreactor that can carry out fermentation of a plant cell…

A:

Q: Usually, the steam pressure in a boiler is controlled through the use of a pressure control loop on…

A: Step 1: In boiler systems, maintaining optimal performance involves managing multiple crucial…

Q: 10 cfm Disturbance 5.9. The liquid-level process shown in Fig. P5–9 is operating at steady state…

A: In process dynamic control, a block diagram is described as a pictorial representation of the…

Q: For the simplified feedback control loop, determine the ultimate gain and period for a P-only…

A:

Q: A surge tank in Fig. is designed with a slotted weirso that the outflow rate w is related to the…

A:

Q: Consider a stirred-tank blending and heating system with variable hold-up volume in Figure 1. Where…

A:

Q: first-order dynamics,

A:

Q: Hot and cold liquids are mixed at the junction of two pipes. The temperature of the resulting…

A:

Q: Q4: For the signal flow graph of a certain control system shown below, find the system…

A: Step 1:Step 2:

Q: A perfectly stirred, constant-volume tank has two inputstreams, both consisting of the same liquid.…

A: Dynamic model represents the behavior of process when it goes from one steady-state to new…

Q: The control system error can be calculated as the difference between the values of the set point and…

A: (1) True The control system errors can be calculated as the difference between values of set point…