5. It's a pair of simplex channels with a fixed and known frequency separatic is. Mark only one oval. FDD Handoff TDD Paging systems 6. It is a commination systems that send brief messages to a subscriber Mark only one oval. FDD Handoff TDD Paging systems 7. It's a switching technique that enables a call to proceed uninterrupted when the user moves from one cell to another. Mark only one oval. FDD Handoff TDD Paging systems 000 000

Q: out the time-ou TCP timer manag 5.

A:

Q: Name the protocol that uses both TCP ports 20 and 21.

A: Given; Name the protocol that uses both TCP ports 20 and 21.

Q: à Can a switching table in a virtual-circuit network have two entries with the same input port…

A:

Q: is transmitting on Ethernet. Write the bit stream in the order of transmitting.

A: Assume that 8 bits of data "10011101" is transmitting on Ethernet. Write the bit stream in the…

Q: True or false, and briefly explain your response to each of the following statements: When the…

A: The statement is true. If the transmitter and receiver window sizes are both 1, the alternating-bit…

Q: Choose "true" or "false" and provide a short explanation for your answer to each of the following:…

A: Answer is

Q: Computer science Short answer Describe the following: a. Additive increase and multiplicative…

A: Introduction: AS PER OUR POLICY “Since you have posted a question with multiple sub-parts, we will…

Q: True or False: One drawback of circuit switching is that resources may be allocated for a connection…

A: True

Q: Q/ An 802.11 header contains two destination addresses. Explain the purpose of each.

A: The purpose of two destination address are described below:

Q: Does this make sense to you, or do you believe it to be incorrect? Consider the most recent…

A: We need to check, if current timeoutinterval value mist be greater than one second or not.

Q: Computer Science If the channel is lossy then how will you provide reliability Purpose your…

A: It is defined as Transmission Control Protocol which is a communications standard that enables…

Q: The alternating-bit protocol is the same as the SR protocol when both the transmitter window size…

A: It is a selective repetition technique used in the data connection layer of the OSI model to ensure…

Q: Does this make sense to you, or do you think it's wrong? Assume that the most recent SampleRTT on a…

A: Introduction: Before attempting a quick retransmit, TCP waits until it receives three duplicate…

Q: Which TCP fields are used in the sliding window method that is employed by TCP?

A: In this question we need to explain the TCP fields which are utilized in sliding window technique…

Q: In TCP, the retransmission timer "adapts" to changing network conditions. What would cause the…

A: TCP adapts well to this type of more or less constant delay. This is because the TCP retransmission…

Q: Different ways to send information Problems that come up when TCP and UPD are used in modern…

A: TCP: Since Transmission Control Protocol (TCP) is connection-oriented, data can be transmitted in…

Q: Is this a good or bad idea? Assume that the most recent SampleRTT on a TCP connection is 1 second.…

A: Round-trip time, or RTT, is the sum of the time required to transmit the first packet to the…

Q: The term "channel bandwidth" is defined by this function. What makes this such an important aspect…

A: Bandwidth of the channel: « As a channel bandwidth is the rate at which data is usually transmitted…

Q: There are eight separate intervals in a "TDMA frame" on a GSM network. The time allotted for each…

A: In a GSM network, a TDMA (Time Division Multiple Access) frame consists of eight separate time…

Q: TCP is Group of answer options Connection oriented Connectionless unreliable unpredictable

A: Given : TCP isGroup of answer options Connection oriented Connectionless unreliable unpredictable…

Q: 5. Program the 8255 PPI with the following specifications: all ports are output ports. Send 55H to…

A: MOV AL, 55HOUT 00H, ALOUT 01H, ALOUT 02H, ALOUT 03H, AL DELAY:MOV CX, 1000DELAY1:LOOP DELAY1 MOV AL,…

Q: Does this make sense to you, or do you believe it to be incorrect? Consider the most recent…

A: In a TCP connection, sampleRTT TCP is a connection-oriented protocol, and connection is required for…

Q: take

A: The correct answer is 3.643

Q: CRC or Cyclic Redundancy Check is an error control method used in Ethernet where a checksum is…

A: According to the information given:- We have to define why is the CRC put in the trailer rather than…

Q: Describe the following: a. Additive increase and multiplicative decrease b. Slow start c. Fast…

A: Additive increase or multiplicative decrease The additive increase or multiplicative decrease…

Q: Does this make sense to you, or do you believe it to be incorrect? Consider the most recent…

A: The answer of the question is given below

Q: In a connection, data can be either sent or received on the wire but not at the same time Select…

A: Here in this question we have asked the connection name in which data can be sent or received on the…

Q: There are two perspectives to consider. It is assumed that the most recent SampleRTT on a TCP…

A: introduction: TCP connections with samplersTCP is a connection-oriented protocol, and connection is…

Q: Suppose that TCP's current estimated values for the round trip time (estimated RTT) and deviation in…

A: TCP, abbreviated as Transmission Control Protocol, constitutes a fundamental component of the…

Q: Is it the case or not? Let's pretend the most recent SampleRTT on your TCP connection was 1 second.…

A: Introduction TCP (Transmission Control Protocol) is a connection-oriented protocol for the…

Q: Which Transmission Control Protocol (TCP) fields are utilized in the implementation of TCP's sliding…

A: The Transmission Control Protocol (TCP) has an inbuilt congestion control mechanism known as the…

Q: Is this correct or incorrect? Assume that on a TCP connection, the most recent SampleRTT is 1…

A: Answer : - False.

Q: Boso Sale Boso Stlon 1 Putvic Swit lephom Nwart (r If a user moves from ce. the cells

A: In a cellular system, as the distributed mobile transceivers move from cell1 to cell2 during an…

Q: is the obtained data unit when decapsulates the frame. d. Segment e. Datagram c. User datagram a…

A: In this question we have been given multiple choice question for the networking and its…

Q: What do you think about the following questions? True or false? When the transmitter and receiver…

A: Explanation:  SR is a selective repeat technique that is utilised in the OSI model's data link layer…

Q: QUESTION 27 TCP uses... stop and wait flow control with stop and wait ARQ error control stop and…

A: FgggddddhhggggggggTCP typically uses sliding window flow control with go back N ARQ error control.…

Q: Answer the following questions with a simple true or false and a short explanation of why you chose…

A: The data link layer protocol known as the SR protocol, or selective repetition protocol, transfers…

Q: The acknowledgment number in a TCP segment is the sequence number of what

A: TCP, or broadcast Control Protocol, plays a critical role in Internet process. It functions at the…